Limitations On Use; Label; Sensor Slots X-Am 8000; Operation - Dräger X-am 8000 Gebrauchsanweisung

|
en

Operation

3.3

Limitations on use

The gas detector is not suitable for measuring process
gasses.
Operation of the gas detector in the charging cradle in a
vehicle is only permitted under the following conditions:
– Acoustic signalling must be deactivated (with the help of
the PC software CC-Vision) so that the driver is not
distracted.
3.4 Approvals
A copy of the rating plate, the declaration of conformity and
the sensor data relevant for measurement purposes are
provided in the enclosed supplementary documentation (part
no. 90 33 655).
Explosion protection:
BVS 17 ATEX E 040 X certifies the intended use in explosion-
hazard areas and the measuring function for explosion
protection. PFG 19 G 001 X certifies the measurement of
oxygen deficiency and oxygen surplus as well as the
measuring function for toxic gases. See the supplementary
documentation for certified gases and measured values (part
no. 90 33 655).
CSA-specific information:
Only the combustible gas part of this instrument has been
tested for measuring accuracy.
Radio approval (X-am 8000 only):
The information for radio approval can be viewed in the menu.
For further information, see the following chapter: "Opening
information", page 39.
Approval-related accessories:
This chapter contains an overview of the key parts covered by
the BVS and PFG certification. Information on other parts can
be found in the spare parts list or can be requested from
Dräger Service. The same ambient conditions that apply for
the gas detector also apply for the accessory. For further
information see: "Gas detector", page 53.
Description
Carrying strap
Calibration adapter
Pump adapter with dust and
water filter
Induction charger
The data logger is not part of the technical suitability test.
3.5

Label

The energy supply label has a mark for a service label. Here,
a maximum of one service label and one year-point label may
be attached one on top of the other. Further labels, conductive
labels or labels with conductive material or parts can have a
negative effect on inductive charging.
34
Part number
8326823
8326821
8326820
8325825
The rating plate on the gas detector must not be
concealed.
3.6

Sensor slots X-am 8000

Term Configuration
Sensor slot
HPP 1 (High Power PID or IR sensor
Port)
HPP 2 (High Power IR or CatEx sensor
Port) (no Dual IR Ex / CO
EC 1-3 (Electro EC sensors
Chemical)
4 Operation
4.1

Operating concept

Navigation is done with the 3 multifeature buttons and the
dynamic navigation bar (see Graphic E on the fold-out page).
The navigation bar changes dynamically depending on the
available interactions.
4.2

Symbol explanations

4.2.1 feature buttons

Symbol Explanation
Confirm action/dialog / return to menu
Confirm all
Scroll up / through display
Scroll down / through display
Cancel action
Display quick menu
Display measuring channels individually
Display all measuring channels
Increase value
Decrease value
Repeat feature
Display menu
4.2.2 Displays
Symbol Explanation
Horn and vibration for gas alarm deacti-
vated
Instructions for use
HC)
2
®
|
X-am 8000