Installing The Power Cord; Connecting To A Power Source - Pit Boss AUSTIN XL Montage- Und Betriebsanleitung

Installation:
NOTE: Both flame broiler parts are lightly coated with oil to avoid rusting
when shipped.
• Insert the flame broiler main plate into the main grill, right side first. Rest
the flame broiler main plate on the built-in ledge (on the inside right) of the
main grill that directs grease towards the grease bucket. Slide the entire
piece to the left side, and the two slots on the flame broiler main plate
will fit into the rounded ledge above the fire pot. It will sit slightly at a
downward angle. Note illustration 11A.
IMPORTANT: If the flame broiler main plate is on the base of the barrel, it
is installed incorrectly. The flame broiler should sit at an angle, with the
left side sitting higher than the right.
• Place the flame broiler slider on top of the flame broiler main plate, covering
the slotted openings. Ensure the raised tab is on the left, to easily adjust for
direct or indirect flame when cooking. Note illustration 11B.
NOTE: When the flame broiler slider is open, and direct flame is used
while cooking, do not leave the grill unattended for any period of time.
• Place the cooking grids, side-by-side, on the grid ledge inside the main grill.
The unit is now completely assembled.
NOTE: To maintain the searing and grilling performance of your cooking
grids, regular care and maintenance Is required.

12. INSTALLING THE POWER CORD

Parts Required:
Power cord (#26)
1 x
1 x Power cord clip (#27)
Installation:
• Place the Power Cord Clip on the Power Cord. Insert the Power Cord into
the groove at the bottom of the hopper. Secure the Power Cord Clip to the
bottom of the hopper using one of the pre-installed screws.

13. CONNECTING TO A POWER SOURCE

NOTE: Before plugging your Pit Boss® into any electrical outlet, ensure
the temperature dial is in the OFF position.
• STANDARD OUTLET
This appliance requires 220-240 V, 50 Hz, 250 W. It must be a 3-prong
grounded plug.
GFCI OUTLETS
•
This appliance will work on most GFCI outlets, with a recommended size
of 15 amp service. If your GFCI outlet is highly sensitive to power surges,
it will likely trip during the start-up phase of operation. During the start-
up phase, the igniter draws 200-700 watts of electricity, which can be too
much power for a GFCI outlet to handle. Each time it trips, it increases in
sensitivity. If the GFCI keeps tripping, replace the outlet or change to a non-
GFCI outlet.
IMPORTANT: Disconnect unit from power source when not in use.
11A
11B
12
13
FAST-BLOW FUSE
11