Connecting To A Gas Supply; Gas Cylinder Requirements; Connecting The Lp Gas Cylinder - Pit Boss PB2BPGG Handbuch

GAS CYLINDER REQUIREMENTS

To operate, you will need a precision-filled standard G30/G31 grill liquid propane ("LP")
gas cylinder with external valve threads. Use standard flexible tube with length less
than 1.5 m (59 in). The tube shall be readily visible across its entire length for inspection
after installation.
The maximum diameter and the maximum height of the cylinder is 300 mm (11.8 in) and
600 mm (23.6 in) as shown in illustration.
CAUTION: You must have the proper regulator which relevant standard
is EN16129 and bottle in order for the barbecue to operate safetly and
efficiently. Use of an incorrect or faulty regulator is dangerous and will
invalidate any warranty. It is important to inspect the full length of the
tube. If it is evident there is excessive abrasion or wear, or the tube is cut,
the tube must be replaced prior to the appliance being used.

CONNECTING THE LP GAS CYLINDER

IMPORTANT: If the manifold requires a connector, follow the connector installation instructions prior to
connecting the unit to a gas cylinder.
1. Before connecting, ensure there is no debris caught in the head of the LP gas cylinder, head of the regulator valve, or in the
head of the burner and burner ports.
2. Connect the tube line to the manifold by turning the knob clockwise until it stops. Make sure that the tube is not twisted in
any way.
3. Place the LP gas cylinder into the cylinder hole. Ensure the hose connected to the cylinder does not touch any of the grill
surfaces that could get hot. Keep the LP gas cylinder in place during operation of the barbecue. Do not place a spare cylinder
in the cylinder enclosure at any time. Allow the the LP gas cylinder to be easily accessible (not blocked) at all times. If the LP
gas cylinder is too tall, it cannot be put into the cylinder hole. The gas cylinder can be attached to the gas cylinder hook on
the right side of the frame or placed on flat ground.
4. Make sure the gas cylinder valve is in OFF position. Ensure the gas cylinder is completely upright, as it is unsafe to operate
the grill if the gas cylinder is not installed properly.
5. Ensure the regulator valve on the grill is completely closed by turning the knob clockwise to the OFF position.
6. Remove the protective caps from the regulator valve opening and the top of the gas cylinder. Save the caps.
7. Insert the gas cylinder valve into the threaded opening of the regulator valve. Turn the cylinder clockwise until firm. Hand-
tighten only.
8. LP gas cylinder is now installed.
WARNING: Shut off the gas cylinder if you smell gas. Attempt to re-install gas cylinder to ensure that tube
is connected properly.

CONNECTING TO A GAS SUPPLY

MAXIMUM DIAMETER
300mm / 11.8 in
MAXIMUM
HEIGHT
600mm /
23.6 in
5