Mounting The Lid Handle; Securing The Lid Support; Installing The Firebox To The Cart - Pit Boss ULTIMATE GRIDDLE-Serie Montageanleitung

7. MOUNTING THE LID HANDLE

Parts Required:
1 x Firebox (#1)
2 x Lid Handle Bezel (#6)
1 x Lid Handle (#7)
Installation:
• Remove the pre-installed screws from the Lid Handle. From inside the
lid of the Firebox, insert one screw to protrude to the outside. Add a
Lid Handle Bezel on the screw, then hand-tighten the screw (from the
inside) into the Lid Handle. Repeat same installation for other end of Lid
Handle.

8. SECURING THE LID SUPPORT

Parts Required:
1 x Lid Support (#5)
3 x Screw (#A)
Installation:
• On the backside of the Firebox, fasten the Lid Support to the center of
the panel using three screws.

9. INSTALLING THE FIREBOX TO THE CART

NOTE: A regulator is shown; however, not all distributors sell the units with
a regulator included. A Manifold Transition Kit is provided should a gas
regulator not come pre-assembled on the griddle. Select the connector
from the Manifold Transition Kit that is required for your gas manifold and
regulator tubing.
Installation:
• Place the Firebox next to the Cart, both facing the same direction. Using
two people, lift the Firebox using the inset grooves on each side. Slowly,
place the Firebox onto the cart frame, passing the regulator and hosing
through the Cart side Panel on the right of the unit. Note illustration 9A.
IMPORTANT: Take care to avoid pinching or damaging the regulator
or hosing during installation of the Firebox to the Cart. Poor
installation may cause the parts to not function properly.
• Once in position, turn the latches (one on each side) to lock the Firebox
into the Cart. Note illustration 9B.
7
7
6
1
8
A
5
A
A
9A
9B
6
7