Mounting Main Barrel To The Cart; Securing Support Plates To The Grill; Installing The Lid Stopper - Pit Boss Navigator PB850G Montageanleitung

6. MOUNTING MAIN BARREL TO THE CART

Parts Required:
1 x Main Barrel (#4)
12 x Screw (#A)
Washer (#B)
12 x
Locking Washer (#C)
12 x
1 x Power Cord (#32)
1 x Cable Clip (#31)
Installation:
• Please replace with the correct power cord for your country, if you find
the power cord does not match the plug you are using.
• Place the cable clips on the correct power cord. Insert the power cord
into the grove at the bottom of the hopper. Secure the cable clip to
the bottom of the hopper with the previously installed screw. Note
Illustration 6A.
• Prepare the Main Barrel to be mounted to the Cart. Carefully, lift the Cart
into an upright position with the wheels on the bottom. Position the
Cart next to the Main Barrel, with both facing the same direction. Lock
the Caster Wheels on the Cart. Using a second person, prepare to lift the
Main Barrel onto the Cart. With one person lifting from the hopper side,
and the other person lifting from the opposing barrel end, carefully lift
the Main Barrel, and slowly lower onto the Cart. Note illustration 6B.
• Next, open the Main Barrel lid. Adjust the rotation as needed to align
the screw holes of the Main Barrel to the Cart. Once placed, secure each
leg to the Main Barrel using three screws, washers, and locking washers.
Note illustration 6C.

7. SECURING SUPPORT PLATES TO THE GRILL

Parts Required:
Screw (#E)
4 x
Installation:
• Secure each Long Support Plate to the Main Barrel using two screws .

8. INSTALLING THE LID STOPPER

Parts Required:
1 x Lid Stopper (#1)
Installation:
• Secure the Lid Stopper onto the top of the Main Barrel using the pre-
installed screw on top of the Main Barrel.
6A
31
32
6B
4
6C
A
C
B
7
8
1
7