Operation; Setting The Working Positions; Inserting/Removing The Rechargeable Battery - Parkside PLVA 40-Li A1 Originalbetriebsanleitung

The collection bag is recommended
for operation with the air roller
( 17)!
A
1. Pull the collection bag over the rods.
2. Put the plastic straps of the collection
bag over the collection bag rods and
clip into the plastic straps.
Mounting the collection bag on the
implement:
3. Lift the impact protector (14).
4. Push the pins on the collection bag
rods into the socket in the implement
case.
5. Release the impact protector so that it
holds the collection bag (12) in its posi-
tion.
Removing and emptying the collec-
tion bag:
6. Lift the impact protector (13) and take
out the collection bag (12).

Operation

Please observe local regulations
concerning noise protection.
Setting the working posi-
tions
The implement has 5 principal position
settings:
+10 mm : Transport position
This position sets the maximum safety
spacing between the tool and the floor.
-3 mm : Working position
Set this position when working with a new
implement.
-3 to -12 mm : Readjustment
The working position can be lowered with
increased knife and sprung tine wear.
Wear can be identified from an increas-
ingly poor result.
The readjusting depth amounts to approx.
3 mm per setting.
When the implement is deliv-
ered it is in the Transport Position
(+10 mm) setting.
1. The implement must be switched off to
set the working position.
2. Adjust the depth adjustment lever
( 11) and allow it to lock into place
A
in the desired position.
Selection of a readjustment position
without the corresponding wear
can overload the motor and dam-
age the cylinder.
Inserting/removing the
rechargeable battery
Switch off the device, pull the igni-
tion key (
drum to come to a stop.
1. To remove the battery (19) from the de-
vice, press the release button (20) on
the battery and pull the battery out.
2. To insert the battery (19), push the bat-
tery along the guide rail into the de-
vice. You will hear it click into place.
GB
positions
21) and wait for the
IE
31