Residual Risk; Operation; Before Starting Up; Mounting - Parkside PDST 10 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Never transport the hose drum by
„ z
taking it by the hoses.
Always hold the hose firmly
„ z
when you disconnect it from
the compressed air source or a
pneumatic tool.

Residual risk

z z
Even if you operate the device as
intended, there will be residual risks.
The following dangers may occur in
connection with the build and design
of this air-driven hose drum:
Danger from beating compressed
„ z
air hoses.
Danger of falling from com-
„ z
pressed air hoses lying around.
Reduce the residual risk by carefully
using the device as intended.
292166_Schlauchtrommel_content_LB6.indb 9
All manuals and user guides at all-guides.com
Safety instructions for pneumatic tools / Operation

Operation

Before starting up

z z
Take all parts from the packaging and check
„ z
whether the air-driven hose drum or parts show
any damage. If this is the case, do not use the
air-driven hose drum. Contact the manufacturer
via the indicated service address.
Remove all protective films and other transport
„ z
packaging.
Check that the delivery is complete.
„ z

Mounting

z z
Finding a mounting spot
Mount the hose drum on a suitable ceiling or
„ z
wall; use of the unmounted hose drum is not
permitted.
Choose a place for mounting the hose drum so
„ z
that it does not pose any obstacle.
Ensure a mounting height of at least 2.5 metres
„ z
for ceiling installation.
You need the following tools for mounting: a
„ z
power drill, a suitable drill bit and a wrench.
Mounting the hose drum
DANGER OF INJURY!
Improper mounting of the hose drum may cause
injury.
Ensure that there are no lines or tubes at the
„ z
mounting site. Use a detector for this if neces-
sary or contact a specialist.
Observe the safety notes for the drill used.
„ z
NOTE! Danger of damage!
Improper mounting may cause damage.
Ensure that the carrier material at the mounting
„ z
site bears the weight of the hose drum. Contact
a specialist if you have any questions.
GB/IE/NI 9
11.12.2017 17:16:22