Operation; Setting The Working Positions; Switching On And Off - Parkside PLV 1500 B1 Originalbetriebsanleitung

The collection bag is recommended
for operation with the air roller
16)!
(
A
1. Pull the collection bag over the rods.
2. Put the plastic straps of the collection
bag over the collection bag rods and
clip into the plastic straps.
Mounting the collection bag on the
implement:
3. Lift the impact protector (13).
4. Push the pins on the collection bag rods
into the socket in the implement case.
5. Release the impact protector so that
it holds the collection bag (12) in its
position.
Removing and emptying the collec-
tion bag:
6. Lift the impact protector (13) and take
out the collection bag (12).

Operation

Please observe local regulations
concerning noise protection.
Setting the working posi-
tions
The implement has 5 principal position
settings:
+10 mm :
This position sets the maximum safety spac-
ing between the tool and the floor.
-3 mm :
Set this position when working with a new
implement.
-3 to -12 mm : Readjustment
Transport position
Working position
positions
The working position can be lowered with
increased knife and sprung tine wear.
Wear can be identified from an increas-
ingly poor result.
The readjusting depth amounts to approx.
3 mm per setting.
When the implement is deliv-
ered it is in the Transport Position
(+10 mm) setting.
1. The implement must be switched off to
set the working position.
2. Adjust the depth adjustment lever
10) and allow it to lock into place
(
A
in the desired position.
Selection of a readjustment position
without the corresponding wear can
overload the motor and damage the
cylinder.

Switching on and off

D
Before switching on the imple-
ment ensure that it is not in
contact with any objects. Keep
your feet and hands well away
from the cylinder and the ejec-
tor opening. Danger of injury!
1. Place the implement on a level lawn
surface.
2. Connect the extension cord to the
power cable (18).
3. Connect the implement to the mains
voltage.
4. To switch on, press the electronic switch
lock (1) on the handlebar and then pull
the start handle (2) towards the handle-
bar. Release the electronic switch lock
(1).
5. To switch off release the starting lever
(2).
GB IE
31