Parkside PLVA 40-Li A1 Originalbetriebsanleitung Seite 27

Use:
• CAUTION – A very sharp tool.
Avoid cutting your fingers or
toes. While working always
keep your feet and fingers well
away from the cutting cylinder
and the ejector opening. There
is the danger of serious injury!
• Do not operate the implement
while it is raining, in poor weather
conditions and when the surround-
ing area and lawn are wet. Op-
erate the implement only during
daylight hours or with bright light-
ing. There is a risk of accidents.
• Do not operate the implement if
you are tired or are lacking in
concentration and after having
drunk alcohol or taken medi-
cine. Always take a work break
in due time. Approach the work
with common sense. A moment
of carelessness when using the
equipment can result in serious
injury.
• Familiarize yourself with the
terrain and remain focused on
the potential hazards that you
could miss on account of the
motor noise.
• Always maintain a secure foot-
ing while working, especially on
a sloping terrain. Always work
across slopes - never up and
down! Be particularly careful
when changing the travelling di-
rection. Do not scarify or aerate
on overly steep slopes. This ena-
bles you to control the equipment
better in unexpected situations.
• Avoid an abnormal body posture.
Walk, do not run.
• Always guide the implement at
a walking pace with both hands
on the handle. Be especially
careful when you turn the imple-
ment around or draw it towards
you. Danger of stumbling!
• Start or operate the start lever with
care corresponding to the instruc-
tions in this instruction manual and
keep your feet at a safe distance
from the prongs.
• Do not tilt the implement when
starting, other than it has to be
lifted. In this case tilt the imple-
ment only to the extent that is ab-
solutely necessary and always
lift the implement on the side that
is opposite to the operator.
• Never operate the implement
without the attached collection
bag or impact protector. Dan-
ger of injury! Never place your
hands or feet on or below rotat-
ing parts. Always keep away
from the ejector opening.
• Do not operate the implement in
the vicinity of inflammable liq-
uids or gases as this could give
rise to the danger of a fire or
explosion.
• Always remove the ignition key
and batteries from the device be-
fore working on it.
• Hold the prongs if the machine
needs to be tipped over for
transport over areas other than
grass and if the machine is
moved from and to the area to
be treated.
• Never transport the machine
while the drive is running.
Work intervals:
• After the implement has been
turned off, the cutting cylinder
will continue to rotate for a few
GB IE
27