Transport; Cleaning/Maintenance; General Cleaning And Maintenance Work; Exchanging The Cylinder - Parkside PLVA 40-Li A1 Originalbetriebsanleitung

• Select the appropriate working or
readjustment position (in the event of
cylinder wear) so that the implement is
not overloaded.
• Guide the implement at a walking
pace down lanes that are as straight
as possible. To ensure uninterrupted
aerating or verticuting the individual
lanes should always overlap by a few
centimetres. Dwelling too long at the
same place while the implement is run-
ning can damage the grass sward.
• Always clean the implement after each
use (see "Cleaning/Maintenance").
• After having treated lawns with dense
moss growth, it is advisable to reseed
the lawn so that it can regenerate itself
quicker.

Transport

• Adjust the transport position (+10
mm) setting (see "Setting the Working
Position") when transporting the imple-
ment.
• Lift the implement to transport it over
steps and sensitive surfaces (e.g. tiles).
Use the handle (

Cleaning/maintenance

Work that has not been de-
scribed in these Instructions
must be carried out by a ser-
vicing agency authorised by
us. Only use original parts.
Wear gloves when handling the
cylinder.
Switch off the device before any
maintenance or cleaning work, pull
the ignition key (
batteries (
9).
A
21), remove the
19) from the device
and wait for the drum (
to come to a stop. Warning! Risk of
injury by dangerous moving parts!
General cleaning and
maintenance work
Do not jet water onto the
implement and do not clean
it under flowing water. This
would result in the danger of
an electric shock and the im-
plement could be damaged.
• When work has finished remove plant
residues adhering to the wheels, inside
the ventilation opening, the grass ejec-
tor opening and the cylinder. Do not
use hard or pointed objects for this
purpose as they could damage the im-
plement.
• Completely empty the collection bag.
• Always keep the implement clean. Do
not use cleaning agents or solvents.
We cannot be held liable for damage
caused by our implements if they were
improperly repaired, if non-original parts
have been used or if they were used not in
keeping with their intended purpose.

Exchanging the cylinder

Switch off the device, pull the igni-
tion key (
teries ( 19) from the device and
wait for the drum to come to a stop.
Wear gloves when handling the
cylinder.
1. Turn the implement over.
2. Loosen the wing screw (22).
3. Pull the bearing support (24) upwards.
GB
16/17)
21), remove the bat-
IE
33