Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Turning The Handle; Switching On And Off; Use As A Floor-Mounted Appliance - Parkside PLHLG 2000 B2 Originalbetriebsanleitung

Langstiel-heißluftgebläse / unkrautvernichter
Vorschau ausblenden Andere Handbücher für PLHLG 2000 B2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Operation

Turning the handle

The device has two handle positions.
Position
Suitable for eliminating weeds and
lighting charcoal.
Position
Suitable for use as a heat gun.
1. To turn the handle (6), move the
lock switch (3) forward towards
the blow-off pipe (1). The "
icon appears.
2. Keep the lock switch (
this position and turn the handle
(6) to the desired position.
3. Release the lock switch (
The icon
whether the handle (6) has
clicked into the desired position
and can no longer be turned.

Switching on and off

Depending on the application, the device
can be set to three temperature levels
using the on/off switch (5).
Level 1 = 100°C
Level 2 = 350°C
Level 3 = 650°C
Switching the device on:
1. Insert the mains plug into a wall sock-
et.
2. Switch the on/off switch (5) to the de-
sired level 1, 2 or 3.
After approximately 1 minute, the
device will reach the full operating tem-
perature.
1
:
2
:
3) in
appears. Check
Switching the device off:
1. To switch the device off, set the on/off
switch (5) to level "0".
2. After using the device, always place
it on its base (
fireproof surface until the device has
cooled down.
3. Remove the mains plug from the socket
Use as a floor-mounted
appliance
You can use the device as a floor-mounted
appliance. For this purpose, place the devi-
"
ce on the two bases (9).
Ensure stability and safety and a heat-re-
sistant surface.
The position as a floor-mounted appli-
3).
ance is also ideally suited to allowing
the device to cool down after use.

Use of adapter nozzles

Before exchanging adapter
nozzles, the adapter nozzle
(15/16/17/18/19) and blow-off
pipe (
cooled down to avoid burns.
Various uses are possible. Always
comply with the safety instructions
and always handle the device with
care and caution.

Restrictor

Place the restrictor (19) on the blow-off
pipe (
1). Use the restrictor (19) to
obtain selective heat, e.g. to seal plastics
(films, shrink tubing).
GB
IE
20) on an even,
1) must be sufficiently
NI
9

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis