Pairing The Mini Wireless Remote Control; Pairing The Dhe Programming Unit As A Wireless Remote Control - STIEBEL ELTRON DHE Connect 18/21/24 Bedienung Und Installation

INSTALLATION
Alternative installation methods

14.13 Pairing the mini wireless remote control

If the programming unit is permanently installed in the appliance,
the mini wireless remote control can be paired via the program-
ming unit (see chapter "Settings / Pairing a new mini wireless
remote control").
However, if the programming unit is used outside the appliance (in
accessories), open the appliance and proceed as described below
to pair the mini wireless remote control.
1 Wireless module button for pairing and unpairing
2 Yellow LED indicator illuminates when mini wireless remote
control is active
f To start pairing the instantaneous water heater, briefly press f
the button. The yellow LED starts to flash.
f Now press the plus (+) button on the mini wireless remote f
control for 3 seconds.
After successful pairing, the yellow LED flashes quickly several
times in succession and then goes out.
106 |DHE Connect | DHE Touch
If the pairing was unsuccessful, the LED continues to flash until
registration mode ends (30 seconds in total).
14.14 Pairing the DHE programming unit as a
If the programming unit is used with accessories outside the ap-
pliance and the appliance is closed with the dummy cap, then the
appliance must be opened to pair the programming unit.
2
1
1 Wireless module button for pairing
2 Yellow LED indicator illuminates when programming unit is
active
f Select the "Settings / Service / Wireless / Pair programming f
unit" menu item on the programming unit.
f Briefly press the wireless module button in the appliance. f
The yellow LED starts to flash. The wireless module remains
in registration mode for 30 seconds.
f Press "OK" on the programming unit. f
wireless remote control
2
1
www.stiebel-eltron.com