Operation Using The Vario Pedal - Nouvag HighSurg 30 Bedienungsanleitung

HighSurg 30
7.8
Treadplate...
... not pressed
... pressed gently
... pressed all the
way down
HighSurg 30 Operating Instructions, Ref. 31666, V24/16
Downloaded from www.Manualslib.com

Operation using the Vario pedal

1
2
1. Carrying bracket
The carrying bracket can be operated by foot (collapsible).
2. Key :
Pressing the key briefly: switches the pump on or off (check display).
Pressing the key longer: increases the pump speed (check display).
In the configuration menu, parameter Level 2 (Pump switch mode on/off) the pump can be set to work
permanently without pressing the treadplate. Therefore only a press on the footswitch
the pump runs with the presetted value. Pressing the footswitch again stops the pump. In this case the
pressing of the pedal has no effect.
3. Key :
Pressing the key briefly: switches the program (+1) (check display).
Pressing the key longer: switches the program (-1) (check display).
4. Key :
Pressing the key briefly: switches the rotational direction (check display).
Pressing the key longer: switches the motor (check display and indicator lights beside the motor
sockets on the control unit).
5. Treadplate
With the treadplate pedal the motor speed is variably adjusted and the pump is activated.
Motor:
Motor off
Motor runs slowly
Motor runs at maximum
speed (speed as set on
the control unit)
manuals search engine
Pump:
Pump off
Pump on, if pump "On"
displayed (speed as set on the
control unit)
Pump on, if pump "On"
displayed (speed as set on the
control unit)
3
4
5
is needed and
Pump permanently on:
If in the configuration menu, parameter Level 2
"Pump switch mode on/off" is activated and the
pump is started by pressing the foot switch.
Pump on, if pump "On" displayed
(speed as set on the control unit)
Pump on, if pump "On" displayed
(speed as set on the control unit)
Pump on, if pump "On" displayed
(speed as set on the control unit)
EN
21