Electric Connection; Transport; Verification Of Raising Ability And Stability Of The Tractor With Rotary Harrow - Alpego DJ serie Betriebs- Und Wartungsanleitung

MANUALE ERPICI PIEGHEVOLI DJ-DP-DK-DMAX

4.12. ELECTRIC CONNECTION

Connect the 7-pole plug (A) of the light-supporting boards with the
tractor
Connect the cables of the C and D boards with the B device; be careful
to match the correct colour of the connector C and D: if the colour is black
it must be connected with the letter N which is present in the B device, if
the colour is red it must be connected with the letter R of the B device .
By using the controls in the tractor (direction blinkers) check which board
must be mounted on the right side of the implement and which one on the
left side.
Secure the brackets 1 on the implement by means of
u-shaped clamps, then secure the arms 2 with a screw and a pin.
Attach the elements 3 to the arms 2.
Mount the light-supporting boards 4 on the supports 3,
plug into the electric system of the tractor. Check which one must be
mounted on the right side and which one on the left side.
Once you are sure of the correct position, secure the boards 4 on the
elements 3.
For the left-side of the implement mount the board and its support
mirroring the position described above
The light-supporting boards have 2 specific positions:
Working position
Trasport position
When the ROTODENT is open and working THE ARMS OF THE LIGHT-SUPPORTING BOARDS MUST BE
LIFTED UP (see picture below)
When you want to FOLD the rotodent to store or to transport it, it is necessary to LOWER THE BOARDS (see
picture below)
WORK
4.13. VERIFICATION OF RAISING ABILITY AND STABILITY OF THE TRACTOR WITH
ROTARY HARROW
Copyright ©2009 della Alpego spa® - All rights are reserved. Reprinting or unauthorized use of this manual is strictly forbidden without written permission by Alpego spa
and insert the
POSITION OF THE LIGHT-SUPPORTING BEAM
Old Cod.D03214
Q00A00017 R.23

TRANSPORT

INSTALLATION
- 21