Positionnament Of 2° Or 3° Category Lower Hitch "Dj - Dp; Universal Central Joint Connection; Universal Side Joint Connection For Rotodent Dp/ Dk; Very Important - Alpego DJ serie Betriebs- Und Wartungsanleitung

MANUALE ERPICI PIEGHEVOLI DJ-DP-DK-DMAX
4.7. POSITIONNAMENT OF 2° OR 3° CATEGORY LOWER HITCH "DJ – DP"
DJ Power Harrow linking points must be covered as shown in the picture according to
the tractor three point hitch class.
DP Power Harrow, according to the tractor connections class, the coupling pins
shall be assembled as shown in the side picture.

4.8. UNIVERSAL CENTRAL JOINT CONNECTION

the protection is a safety
element, never utilize the
machine without this
component
4.9. UNIVERSAL SIDE JOINT CONNECTION FOR
ROTODENT DP/ DK
The side universal joints shall be placed into the suitable slots so that the spiders
at both the sides of the change gear were always in phase with one another, as
indicated in the figure.
VERY IMPORTANT: when installing the automatic drive shafts make sure to
position them correctly (right hand one to the right and left hand one to the left)
Read and follow the indications contained in the instruction manual relating to the universal
joint.

4.10. UNIVERSAL SIDE JOINT CONNECTION FOR ROTODENT DJ / DMAX

The lateral universal joints will be positioned into the corresponding
slots so that the yokes at both sides of the gear box are always aligned
with one another, as shown in the picture.
The two templates "A" won't allow for a wrong positioning.
VERY IMPORTANT: when installing the automatic drive shafts make
sure to position them correctly (right hand one to the right and left
hand one to the left)
Read and follow the directions contained in the owner's manual of the
universal joint.
Copyright ©2009 della Alpego spa® - All rights are reserved. Reprinting or unauthorized use of this manual is strictly forbidden without written permission by Alpego spa
Connect the central universal joint to the power takeoff of the
machine by inserting the two buttons C into the suitable slots.
Check that the min. and max. length of the
joint were compatible with the required working lengths.
Connect to the tractor the opposite end of the universal joint
by verifying that the button was inserted into the suitable slot
GEAR BOX SEEN FROM THE TOP
Old Cod.D03214
Q00A00017 R.23
INSTALLATION
- 18