Danger Of Crushed Fingers; Extra Caution - Risk Of Injury To Children; Dangers Due To Wear And Tear; Battery Warning Notices - Crivit 327387_1904 Gebrauchsanweisung

D anger of crushed fin-
gers!
• Watch out for pinch points when
folding up and unfolding the row-
ing machine.
E xtra caution – risk of
injury to children!
• Keep children away from the
packaging materials. There is a
risk of suffocation!
• The product is not suitable play
equipment and must be stored
somewhere that is inaccessible to
children when not in use. To elimi-
nate the risk of injury, the product
must not be within reach of chil-
dren during the workout.
• Point out to children specifically
that the product is not a toy.
• Children should not be allowed
play with the product.
D angers due to wear and
tear
• The product may only be used if
it is in perfect condition. Check
the product for damage or wear
before each use.
The safety of the rowing machine
can only be guaranteed if it is reg-
ularly inspected for damage and
wear and tear. If, for example, the
chain or the handles of the pull
rod show signs of damage, do not
use the product any more.
• Use only original replacement
parts.
• Protect the product from extreme
temperatures, sun and dampness.
Improper storage and use of the
product could lead to premature
wear and tear, and possible
breakages in the structure, which
could result in injuries.
• Check the product regularly for
damage or deterioration. If the
product is damaged, you must not
use it any longer.
• Do NOT secure or screw the
device permanently to the floor.
Non-compliance can cause con-
siderable damage to the device.
28 GB/MT
B attery warning notices
• Remove the batteries when they
are flat, or if the product is not in
use for an extended period.
• Do not use different types or
brands of battery or new and used
batteries together or batteries with
different capacities as these can
leak and cause damage.
• Ensure the polarity (+/-) is correct
when inserting the batteries.
• Replace all batteries at the same
time and dispose of the old batter-
ies as prescribed.
• Warning! Batteries must not be
charged or reactivated by other
means, must not be taken apart,
thrown into fire or short-circuited.
• Always keep batteries out of reach
of children.
• Do not use rechargeable batteries!
• Cleaning and maintenance must
not be carried out by children
without supervision.
• Clean the battery and device
contacts as needed and before
inserting.
• Do not expose the batteries to
extreme conditions (e.g. radiators
or direct sunlight). Otherwise there
is an increased risk of leakage.
• Batteries can be life-threatening if
swallowed. Therefore, store batter-
ies in a place inaccessible to small
children. Medical attention must
be sought immediately if a battery
is swallowed.

Danger!

• Handle damaged or leaking
batteries with extreme caution and
dispose of them properly as soon
as possible. Wear gloves when
doing so.
• If you come into contact with bat-
tery acid, wash the affected area
with soap and water. If battery
acid gets in your eye, rinse it with
water and seek medical attention
immediately!
• The connection terminals must not
be short-circuited.
Inserting the batteries into the
product (Fig. N)
CAUTION: observe the following
instructions to avoid mechanical
and electrical damage.
Insert the enclosed batteries (25) into the battery
compartment (8d) of the cockpit (8).
Inserting the batteries
1. Undo the screw on the battery compartment
cover (8c) on the back of the cockpit (8) and
remove the battery compartment cover (8c).
2. Carefully insert the 2 x 1.5V type D batteries
(25) into the battery compartment (8d). The
batteries must be fully inserted into the battery
compartment (8d).
CAUTION: check the positive/
negative poles of the batteries (25) and
ensure that they are inserted correctly, as
marked on the bottom of the battery compart-
ment (8d).
3. Attach the battery compartment cover (8c) to
the back of the cockpit and screw the screw
back in again.
Replacing the batteries
CAUTION: observe the following
instructions to avoid mechanical
and electrical damage.
When the batteries (25) are flat, replace them
as described in the insertion instructions above.
Remove the batteries from the product before
inserting new ones.
Notes on setting up
• Choose an exercise area of approx. 3 x 1.8m
(L x W).
• Train on a flat, non-slip surface only.

Assembly

The product should be assembled by
two people.
Step 1 (Fig. C):
1. Attach the two front legs (9a), (9b) to the front
foot (3).
Note: make sure that the curved parts on the
two legs (9a), (9b) are each facing outwards.
2. Then attach the two long legs (9a), (9b) to the
base frame (1).
Note: to make it easier to assemble the legs,
turn the base frame so that the screw holes are
facing upwards.
Step 2 (Fig. D):
1. Leave the base frame (1) inverted and mount
the middle foot (7).
Note: after completing the assembly of the
rowing machine, the floor height level can be
adjusted with the thumbscrew.
2. Adjust the floor height level with the thumb-
screw and then tighten the lock nut (7a).
Step 3 (Fig. E):
Leave the base frame (1) inverted and mount the
two footrests (6a), (6b).
Note: make sure they are correctly oriented (left
(6a)/right (6b)).
Step 4 (Fig. F):
Attach the rear foot (4) to the slide rail (2).