Noise & Vibration Declaration Statement; Additional Vibration Information - Atlas Copco TEX 14PS Betriebsanleitung

TEX P
noise & Vibration Declaration
Statement
Guaranteed sound power level
EN ISO 744 in accordance with directive 2000/14/
EC.
lp
Sound pressure level
ISO 1120
A
Vibration value and uncertainty
with EN ISO 8662-5. Please see table "Noise and
vibration data" for values A, B, etc.
These declared values were obtained by laboratory
type testing in accordance with the stated directive
or standards and are suitable for comparison
with the declared values of other tools tested in
accordance with the same directive or standards.
These declared values are not adequate for use
in risk assessments and values measured in
individual work places may be higher. The actual
exposure values and risk of harm experienced by
an individual user are unique and depend upon the
way the user works, in what material the breaker is
used, as well as upon the exposure time and the
physical condition of the user, and the condition of
the breaker.
We, Atlas Copco, cannot be held liable for the
consequences of using the declared values,
instead of values reflecting the actual exposure,
in an individual risk assessment in a work place
situation over which we have no control.
© 2005 Atlas Copco Construction Tools AB
lw
according to
in accordance with EN
B
in accordance
|
No. 9800 0650 90
Safety and Operating instructions
Additional Vibration
Information
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed.
This additional vibration information may be
of assistance to employers in meeting their
obligations (for example under EU Directive
2002/44/EC) to assess the risks to their workers
arising from hand arm vibration associated with the
use of this tool.
The vibration emission varies greatly with task and
operator technique. The declared vibration value
relates to a single axis on the non-trigger handle
and much higher vibration levels may occur at
other hand positions or measurement directions.
We believe that normal intended use of the tool will
usually produce three axes vibration emissions in
C
the range of m/s
E
range of m/s
2
values, as defined in ISO 549-1:2001) depending
on the details of the task, but emissions outside
this range may occur for some applications.
D
A figure of m/s
asphalt is probably a useful average emission
value when, for example, estimating the likely
average exposures (and hence risk in accordance
with EU Directive 2002/44/EC) of users performing
a wide range of tasks within the intended use of
the tool. We point out that application of the tool
to a sole specialist task may produce a different
average emission and in such cases we strongly
recommend a specific evaluation of the vibration
emission.
We recommend a programme of health
surveillance to detect early symptoms that may
relate to vibration exposure, so that management
procedures can be modified to help prevent
significant disability.
|
2005-12-07
breaking concrete and in the
2
breaking asphalt (vibration total
F
for concrete and m/s
2
for
2
19