Tightening Torques; Actions Before Transport And Storage; Troubleshooting; Disposal Of Used Machine - Atlas Copco TEX 14PS Betriebsanleitung

TEX P

Tightening torques

TEX 20-21
1. Nut, 140 Nm
2. Nipple, 250 Nm.
(Use Loctite 24)
. Nut, 70 Nm
TEX P
1. Screw plug, 200 Nm
2. Nut, 50 Nm
. Swivel nut
(Use loctite 24)
© 2005 Atlas Copco Construction Tools AB

Actions before transport and storage

►
►
►

Troubleshooting

If the pneumatic breaker does not start, has low
power or uneven performance, check the following
points.
►
►
nOTE! To much lubrication can cause starting
►
►
►
►

Disposal of used machine

A used machine must be treated and deposed of
in such a way that the greatest possible portion
of the material can be recycled and any negative
influence on the environment is kept as low as
possible.
| |
No. 9800 0650 90 2005-12-07
Safety and Operating instructions
Make sure that the machine is properly cleaned
before storage.
Pour approx. 5 cl of oil directly into the air inlet
nipple, connect the machine to the compressed
air supply and start it for a few seconds.
Always store the machine in a dry place.
Check that the insertion tool being used has the
correct shank dimension.
Check that the pneumatic breaker is getting the
correct amount of lubricant.
problems, low power or uneven
performance.
Check that the compressed air system supplies
the machine with sufficient air pressure to get
full power.
Check the dimension and length of the air hose
are according to the recommendations. See
"Installation".
If there is a risk of freezing, check that the
machine´s exhaust ports are not blocked.
If the machine function is still not satisfactory
after this procedure, contact an authorised
service workshop.
17