Choosing Insertion Tool; Checking For Wear; Start And Stop - Atlas Copco TEX 14PS Betriebsanleitung

Safety and Operating instructions

Choosing insertion tool

A correct insertion tool is a condition for a good
operation. To avoid unnecessary machine
damages, it is important to choose insertion tools
with a high quality.
Recommended insertion tools are listed in the
machine´s spare parts list.
The narrow chisel should be used for demolition and
cutting work in concrete and other types of hard material.
The moil point should only be used for creating holes in
concrete and other types of hard material.
The wide chisel should be used in soft materials e.g.
asphalt and frozen ground.
Always use a sharp tool to be able to work
effectively. A worn out tool causes increased
vibrations and the operation will take longer.
14

Checking for wear

Using an insertion tool with a worn out shank leads
to increased machine vibrations. To avoid getting
increased vibrations, check the shank for wear
before the insertion tool is fitted in the machine.
Use the gauge that corresponds to the insertion
tool's shank dimension. If the gauge's hole (2) can
be pushed down on the insertion tool's shank, this
means that the shank is worn out and the insertion
tool should be replaced.

Start and stop

Starting position: The start and stop device is in the
upper position. Start the pneumatic breaker by pressing
down the start and stop device.
© 2005 Atlas Copco Construction Tools AB
TEX P
| |
No. 9800 0650 90 2005-12-07