Starting A Cut; Operation - Atlas Copco TEX 14PS Betriebsanleitung

TEX P
Stop the machine by releasing the start and stop device.
The start and stop device returns automatically to the
stop position.

Starting a cut

► Stand steady and make sure that your feet are
at a safe distance from the insertion tool.
► Press the machine against the surface of the
workpiece before starting.
► Adjust the breaking distance (A) so that the
insertion tool does not get stuck.
► Do not try to cut too big a bite.
► Trying to loosen an insertion tool that is stuck
will expose the operator to unnecessary
vibrations.
© 2005 Atlas Copco Construction Tools AB

Operation

►
►
►
►
►
►
| |
No. 9800 0650 90 2005-12-07
Safety and Operating instructions
Let the machine do the work; do not press too
hard. The vibration-absorbing handle must
absolutely not be pressed all the way down to
the base.
Pneumatic breakers with vibration-absorbing
handles: The feed force should be adapted so
that the handles are pressed down "half way".
The best vibration damping and breaking effect
is achieved at this position.
Avoid working in extremely hard materials e.g.
granite and reinforcing iron (re bar) which would
cause substantial vibrations.
Any form of idling, operating without insertion
tool or operating with an uplifted machine must
be avoided.
When the machine is lifted, the start and stop
device must not be activated.
Check regularly that the machine is well
lubricated.
15