Herunterladen Inhalt Inhalt Diese Seite drucken

Setting And Activating/Deactivating Upper Temperature Alarm; Setting And Activating/Deactivating Lower Temperature Alarm - Conrad 67 28 61 Bedienungsanleitung

Funk-wetterstation mit usb und touchscreen
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

 Setting and Activating/Deactivating Upper Temperature Alarm
The alarm/threshold se there only applies for the temperature display set initially (measured temperature
= „TEMP", wind chill temperature = „WINDCHILL" or dew point temperature = „DEW POINT"). An alarm
can be set for each of the 3 temperature displays.
• Touch the display area „OUT TEMP" repeatedly until the outdoor temperature and the display „HI AL" flashes.
• Select the upper threshold with the buttons „+" and „-". Keep the respective button pressed for quick adjustment.
• Use the button „ON/OFF" to switch the alarm function on or off.
With the alarm function on, the icon „
exceeded, the weather station will emit an alarm. It is deactivated by touching the display in any location. The display
„HI AL" and the icon „
To get to the next subfunction (setting and activating/deactivating the lower temperature alarm) -> touch
the display area „OUT TEMP" briefly
Leaving setting mode -> touch another display area (or wait for 30 seconds without touching the touch
screen)
 Setting and Activating/Deactivating Lower Temperature Alarm
The alarm/threshold se there only applies for the temperature display set initially (measured temperature
= „TEMP", wind chill temperature = „WINDCHILL" or dew point temperature = „DEW POINT"). An alarm
can be set for each of the 3 temperature display.
• Touch the display area „OUT TEMP" repeatedly until the outdoor temperature and the display „LO AL" flashes.
• Select the lower threshold with the buttons „+" and „-". Keep the respective button pressed for quick adjustment.
• Use the button „ON/OFF" to switch the alarm function on or off.
With the alarm function on, the icon „
undercut, the weather station will emit an alarm. It is deactivated by touching the display in any location. The display
„LO AL" and the icon „
To get to the next subfunction (displaying/resetting the maximum value storage) -> touch the display area
„OUT TEMP" briefly
Leaving setting mode -> touch another display area (or wait for 30 seconds without touching the touch
screen)
84
" appears below the display „HI AL". When the threshold value set is
" continue to flash, however, until the measured value drops below the threshold value set.
" appears above the display „LO AL". When the threshold value set is
" continue to flash, however, until the measured value rises above the threshold value set.

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis