C) Activating / Deactivating The Warning Signal; D) Setting The Comfort Range For Display A - Conrad WS55 Bedienungsanleitung

c) Warning signal
The built-in signal transmitter emits a warning signal if the latter is activated and if a frost
warning or a temperature alarm (over or under temperature) occurs. If a warning or an alarm
exists, the warning signal is emitted for 30 seconds first then for approximately 3 seconds in
a 30 second cycle.

The warning signal is activated or deactivated for all sensors simultaneously.
1. Activate the warning signal
• Long press the "MIN MAX" and "SELECT " buttons simultaneously.
• The display goes out briefly and the writing "ON" is displayed next to the frost warning
symbols and the HI/LO status indications in both measured value displays.
Afterwards, the device goes back to the normal display.
2. Deactivate the warning signal
• Long press the "MIN MAX" and "SELECT " buttons simultaneously once more.
• The display goes out briefly and the writing "OFF" is displayed next to the frost warning
symbols and the HI/LO status indications in both measured value displays.
Afterwards, the device goes back to the normal display.

d) Setting the comfort range for display A

For display A, which is set by default to display the temperature of pool sensor "PS55", it is
possible to set an individual temperature range, that should be considered to be comfortable.
The comfort indicator via the comfort symbol serves here to determine if the controlled
temperature is in the desired range.
The comfort range is delimited by the adjustable comfort range lower and upper thresholds.
The comfort indicator has thereby the following meanings:
☺
The temperature is within the comfort range
The temperature is lower than 2°C (3.6°F) outside the comfort range
The temperature is higher than 2°C (3.6°F) outside the comfort range
52