D) Setting Wake-Up And Alarm Functions - Conrad WS 1173 Bedienungsanleitung

d) Setting Wake-Up and Alarm Functions

When certain measured values are exceeded or undercut, the weather station may output a
signal sound. A wake-up time can be set as well. The following settings can be made:
Mode "HI AL" (= High-Alarm, alarm when a set measured value is exceeded)
• Setting wake-up time (hour/minute)
• Indoor humidity
• Indoor temperature
• Outdoor humidity
• Outdoor temperature
• Outdoor dewpoint temperature:
• Barometric pressure
Mode "LO AL" (= Low-Alarm, alarm when a set measured value is undercut)
• Setting wake-up time (hour/minute)
• Indoor humidity
• Indoor temperature
• Outdoor humidity
• Outdoor temperature
• Outdoor dewpoint temperature
• Barometric pressure
Proceed as follows:
• First push the button "ARM" repeatedly to select whether you want to change the settings
for the High-Alarm (in the display "HI AL") or the settings for the Low-Alarm ("LO AL").
- Briefly push the button "ALARM" 1x -> Change settings for High-Alarm ("HI AL") (Alarm
when exceeding a specific measured value); the display shows "HI AL"
- Briefly push the button "ALM" 2x -> Change settings for Low-Alarm ("LO AL") (Alarm when
undercutting a specific measured value); the display shows "LO AL"
- Briefly push the button "ALM" 3x -> Cancel; return to regular display

Each time, the display shows if an alarm is already active. For this, the symbol "
is displayed in the corresponding display area.
"
47