Conrad 67 28 61 Bedienungsanleitung Seite 64

• With proper DCF reception (the DCF receiver is installed in the temperature/humidity sensor housing and transfers
its data to the weather station), the time and date are displayed correctly as well. Additionally, the radio tower icon
„ " is displayed at the bottom left of the display.
If no data from the outdoor sensors or DCF time are displayed at the weather station, observe the following:
• Recognition and assessment of the DCF signal by the receiver in the temperature/humidity sensor will take several
minutes.
If you have inserted the batteries in the temperature/humidity sensor and the weather station in quick sequence,
measured values may be displayed already after a while, but no DCF data. Just wait for a few minutes.
The transmitter in the temperature/humidity sensor transfers data to the weather station about every 48 seconds;
therefore, it may take some time until measured values (or the DCF time and date) are displayed.

Wait for a few minutes without touching the touch screen.
• Do not put the weather station right next to any other electronic devices, metal parts, cables, lines, sockets, etc.,
since this may reduce the reception quality for the transmitter signal.
• Reduce the distance between weather station and outdoor sensor. If the reception conditions are detrimental (e.g.
reinforced concrete build, metallised isolation glass windows, aluminium windows, etc.), range may be greatly reduced.
• The DCF receiver in the temperature/humidity sensor housing will try to receive the DCF signal every hour.
• Check the cable connections between the sensors.
• Check that the batteries or rechargeable batteries are inserted correctly.
• If you still do not see the outdoor sensor data or correct time/date on the display after 10 minutes, remove the
batteries from the weather station and the rechargeable batteries from the outdoor sensor.
Wait for at least 10 seconds and then proceed as described in chapters 9 a) and b).
Alternatively, you may briefly push the rest button recessed at the bottom of the solar module.
64