A) Display Area „Time; Setting The Display Contrast; Selecting 12/24H Mode; Setting The Time Manually - Conrad 67 28 61 Bedienungsanleitung

a) Display Area „TIME"
The following setting and subfunctions are available:

• Setting the Display Contrast

• Setting the Time Zone
• Selecting 12h/24h Mode
• Manually setting the time (if no DCF reception is possible)

Touch the display area „TIME" briefly repeatedly until the desired subfunction flashes.
 Setting display contrast
• Touch the display area „TIME" repeatedly until „lcd...." flashes.
• Adjust contrast with the buttons „+" and „-".

To get to the next subfunction (setting time zone) -> touch the display area „TIME" briefly
Leaving setting mode -> touch another display area (or wait for 30 seconds without touching the touch
screen)
 Setting the Time Zone
• Touch the display area „TIME" repeatedly until a number between „-12" and „12" flashes. Here, the time zone in
which the weather station is operated can be set. The respective figure set is the number of hours added to the GMT
time or subtracted from it (GMT = Greenwich Mean Time, time on the zero meridian that runs through the town of
Greenwich near London).
• Adjust the time zone with the buttons „+" and „-".

To get to the next subfunction (select 12h/24h mode) -> touch the display area „TIME" briefly
Leaving setting mode -> touch another display area (or wait for 30 seconds without touching the touch
screen)
 Selecting 12h/24h Mode
• Touch the display area „TIME" repeatedly until „24Hr" or „12Hr" flashes.
• Select the desired display mode with the buttons „+" and „-". In 12h mode, „PM" is displayed to the left of the hours
in the second half of the day.

To get to the next subfunction (manually setting the time) -> touch the display area „TIME" briefly
Leaving setting mode -> touch another display area (or wait for 30 seconds without touching the touch
screen)
 Manually setting the time

The time (and date) is usually set automatically. The DCF receiver in the temperature/humidity sensor
housing transfers the data to the weather station by radio.
Under difficult reception conditions (no reception), e.g. at too high a distance to the DCF sensor), the time
can be set manually.
The date can be set in the display range „DATE", see chapter 11. b).
67