Selecting The Alarm Function Or Viewing The Alarm Time; Activating/Deactivating The Alarm Function; Switching The Alarm Function On/Off; Setting The Alarm - Conrad TE827NL Bedienungsanleitung

Step 11:
The hours blink on the display. Set these with the button " " (6) or " " (7). Confirm the setting by pressing the
"SET" button (5).
Step 12:
The minutes blink on the display. Set these with the button " " (6) or " " (7). Confirm the setting by pressing the
"SET" button (5).
Step 13:
The seconds are automatically set to "00", the settings are saved and you quit setup mode.
 Selecting the alarm function or viewing the alarm time
• First select the function "Time/date" (symbol "
• Then briefly press the button "ALARM/CHART" repeatedly until the desired alarm function appears:
Symbol " W": The alarm function is only triggered on weekdays (from Monday to Friday).
Symbol " S"): The alarm function is only triggered once and then deactivated automatically.
Symbol "PRE AL": In case of low outdoor temperatures (below approx. 2°C), the so-called pre-alarm is triggered
at a set time (15, 30, 45, 60 or 90 minutes) prior to the actual alarm time. This gives you enough time to e.g. defrost
your car windows or shovel snow.

To be able to activate resp. set the pre-alarm (display "PRE-AL"), you first have to activate the alarm
function "
 Switching the alarm function on/off
• First select the function "Time/date" (symbol "
• Then briefly press the button "ALARM/CHART" repeatedly until the desired alarm function appears (see above).
• With the button " " (6) or " " (7), you activate the selected alarm function (alarm time appears) or deactivate it
(display shows "OFF").

To be able to activate resp. set the pre-alarm (display "PRE-AL"), you first have to activate the alarm
function "
 Setting the alarm time

You must be located in the function "Time/date" (symbol "
(6) or " " (7).
• By briefly pressing the button "ALARM/CHART" (1), select the desired alarm function "
• Activate the previously selected alarm function (button " " (6) or " " (7)), so that an alarm time is displayed
instead of "OFF".
• Now keep the button "ALARM/CHART" (1) depressed until the hours of the alarm time blink. Set the hours with
the button " " (6) or " " (7). Confirm the setting by briefly pressing the "ALARM/CHART" button (1).
• The minutes of the alarm time blink, set these with the button " " (6) or " " (7). Confirm the setting by briefly
pressing the "ALARM/CHART" button (1).
• Now the display shows "SNZ" and the minutes for the so-called snooze function ("SNOOZE") blink. With the button
" " (6) or " " (7) you can set a time from 1 to 15 minutes. Confirm your setting by briefly pressing the button
"ALARM/CHART" (1).
Now press the button "ALARM/CHART" (1) briefly and repeatedly until the current time is displayed again.
All manuals and user guides at all-guides.com
" blinks) with the button " " (6) or " " (7).
W" or " S" (otherwise it is of course not possible to trigger a pre-alarm).
" blinks) with the button " " (6) or " " (7).
W" or " S" (otherwise it is of course not possible to trigger a pre-alarm).
" blinks). Select this with the button " "
W" or " S".
79