Using Examples - Yamaha RX-V3800 Bedienungsanleitung

Saving and recalling the system settings (System Memory)
Loading by the SET MENU operation
Press G SET MENU on the remote control.
1
The top menu appears in the GUI.
2
Press 4 k / n repeatedly to select "System
Memory" and then press 4 h.
The "System Memory" menu appears in the GUI.
3
Press 4 k / n to select "Load" and then
press 4h.
The following menu appears in the GUI.
Current
Memory1
Memory2
4
Press 4 k / n repeatedly to select the desired
memory number where the system settings
are stored and then press 4 h.
Once "Load: ENTER" appears in the GUI, press
4ENTER to confirm the loading.
y
You can cancel the loading by pressing 4l.
Memory1
Memory2
Memory3
Memory4
Memory5
Press G SET MENU to exit from GUI screen.
5
100
En
Sci-Fi
SpeakerCH 3/2/0.1
LFE Level 0dB
D-Range MAX
PEQ YPAO Natural
Pure Direct
SpeakerCH 5/4/0.1
LFE Level 0dB
D-Range MAX
PEQ YPAO Flat

Using examples

Example 1: Comparing the results of the
automatic setup and manual setup
This unit is equipped with three types of parametric
equalizer settings (see page 40), and you can also make
your customized configuration of the sound settings of this
unit by using the "Manual Setup" parameters (see
page 82). To compare the results of the automatic setup or
your manual configuration, use the NSYSTEM
MEMORY buttons.
SYSTEM MEMORY 1
The current settings of this unit
SYSTEM MEMORY 2
The results of the automatic setup
(Equalizing: Check:Natural)
SYSTEM MEMORY
2
1
CLASSICAL LIVE/CLUB ENTERTAIN
5
6
SYSTEM MEMORY 3
The results of the automatic setup
(Equalizing: Check:Front)
Saving each setting
Note
Carry out the following procedure when all the parameters are set
to default values.
Press and hold N SYSTEM MEMORY 1 for
1
four seconds.
This unit stores the current settings of this unit to
"Memory1".
2
Perform the automatic setup.
Set "Equalizing" to "Check:Natural". See page 40 for
details.
Press and hold N SYSTEM MEMORY 2 for
3
4 seconds.
This unit stores the results of the automatic setup
performed in step 2 to "Memory2".
4
Perform the automatic setup again.
This time, set "Equalizing" to "Check:Front".
Press and hold N SYSTEM MEMORY 3 for
5
4 seconds.
This unit stores the results of the automatic setup
performed in step 4 to "Memory3".
3
4
MOVIE
8
7