Yamaha RX-V3800 Bedienungsanleitung Seite 89

HDMI Resolution
(HDMI video signal resolution)
Use this feature to activate or deactivate the HDMI up-
scaling of the analog video signals input at the composite
video, S-video and component video jacks so that the up-
scaled analog video signals are output at the HDMI OUT
jack.
This unit up-scales the analog video signals as follows:
• 480i (NTSC)/576i (PAL) → 480p/576p, 1080i,
720p, or 1080p
• 480p/576p → 1080i, 720p, or 1080p
Choice
Through
Does not up-scale any analog video signals.
480p (or Up-scales analog video signals to 480p or 576p,
1080i, 720p, or 1080p of resolution.
576p), 1080i,
720p, 1080p
Notes
• This menu item is not available and hence not visible in the GUI
menu if "Conversion" is set to "Off" (see page 86).
• This unit does not up-scale the digital video signals input at the
HDMI input jacks.
HDMI Aspect (HDMI aspect ratio)
Use this feature to select the adjustment of aspect ratio for
analog video signals output at the HDMI OUT jack.
Choice
Through Does not make any adjustments to the aspect
ratio for the HDMI video signal sources.
16:9 Normal Displays video images with the aspect ratio of
4:3 on your video monitor with the aspect ratio
of 16:9. Black stripes appear on the right and
left sides as a result.
Smart Zoom Fits video images with the aspect ratio of 4:3 to
your video monitor with the aspect ratio of 16:9.
Notes
• When "HDMI Resolution" is set to "Through", you cannot
make any adjustments to "HDMI Aspect".
• If the aspect ratio of the input video source is other than 4:3, this
unit automatically ignores the setting of "HDMI Aspect".
• When "HDMI Aspect" is set to "Smart Zoom", the video
images of the edge of the video monitor are rather stretched.
• When the video signals are input at HDMI IN jacks or the
signals are input with 720p, 1080i or 1080p of resolution, the
setting of "HDMI Aspect" does not affect the video signals
output at the HDMI OUT jack.
Functions
Functions
Graphical user interface (GUI) screen
Short Message (Short message display)
Use this feature to activate or deactivate the short message
display function.
Choice
On
Activates the short message display function.
The contents of the front panel display appear at
the bottom of the screen each time you operate
this unit.
Off Deactivates the short message display function.
Note
The short message display does not appear in the following cases:
– when the component video signals with 720p, 1080i or 1080p
resolutions are input
– when HDMI video signals are input
On Screen (On-screen display time)
Use this feature to set the time for which the iPod or NET/
USB menu is displayed on the video monitor after you
perform a certain operation.
Choice
Always Displays the OSD unceasingly during an
operation.
10sec Turns off the OSD 10 seconds after you perform
a certain operation.
30sec Turns off the OSD 30 seconds after you perform
a certain operation.
Position (GUI screen position)
Use this feature to adjust the vertical and horizontal
position of the GUI screen.
Control range: –5 (downward/left) to +5 (upward/right)
Short Message
On Screen
Position
Wall Paper
Button Moving direction of the GUI display
4 k
Up
4 n
Down
4 h
Right
4 l
Left
Functions
Functions
/ :0 / :0
+
87
En