Yamaha RX-V3800 Bedienungsanleitung Seite 127

Problem
Short message "Short Message" is set to "Off".
displays do not
"Conversion" is set to "Off".
appear in the video
monitor.
The signals input at the HDMI input jacks
are being output at the HDMI OUT jack.
HDTV video signals are being input.
The sound suddenly
The protection circuitry has been activated
goes off. because of a short circuit, etc.
The sleep timer has turned off this unit.
The sound is muted.
Sound is heard from Incorrect cable connections.
the speaker on one
side only.
Incorrect settings in "Speaker Level".
Only the center When playing a monaural source with a
speaker outputs
CINEMA DSP program, the source signal
substantial sound. is directed to the center channel, and the
front and surround speakers output effect
sounds.
No sound is heard "Center" in "Speaker Set" is set to "None".
from the center
One of the HiFi DSP programs (except for
speaker.
"7ch Stereo") has been selected and
analog 2-channel source is being input.
No sound is heard The sound field programs are turned off.
from the presence
You are using a source or program
speakers.
combination that does not output sound
from all channels.
No sound is heard "Surround" in "Speaker Set" is set to "None".
from the surround
This unit is in the "STRAIGHT" mode
speakers.
and a monaural source is being played
back.
No sound is heard "Bass Out" in "Speaker Set" is set to
from the subwoofer. "Front" when a Dolby Digital or DTS
signal is being played.
"Bass Out" in "Speaker Set" is set to
"SWFR" or "Front" when a 2-channel
source is being played.
The source does not contain low-
frequency signals.
No sound is heard "Surround" in "Speaker Set" is set to
from the surround
"None" and "Surround Back" is
back speakers. automatically set to "None".
"Surround Back" in "Speaker Set" is set to
"None".
CINEMA DSP 3D mode is active.
Cause
Set "Short Message" to "On".
Set "Conversion" to "On".
Check that the speaker impedance setting is correct.
Check that the speaker wires are not touching each
other and then turn this unit back on.
Turn on this unit, and play the source again.
Press E MUTE or C VOLUME +/– on the remote
control to resume audio output.
Connect the cables properly. If the problem persists,
the cables may be defective.
Adjust the "Speaker Level" settings.
Set "Center" to "Small" or "Large".
Try another sound field program if you want to output
sound from the center speaker.
Press P STRAIGHT to turn them on.
Try another sound field program.
Set "Surround" to "Small" or "Large".
Press P STRAIGHT on the front panel so that
"STRAIGHT" disappears from the front panel
display.
Set "Bass Out" to "SWFR" or "Both".
Set "Bass Out" to "Both".
Set "Surround" and "Surround Back" to a setting
other than "None".
Set "Surround Back" to a setting other than "None".
Set the CINEMA DSP 3D mode to "OFF".
Troubleshooting
Remedy
See
page
87
86
33, 120
—
—
43
15
91
89
45
50
41
89
50
89
89
89
89
50
125
En