Yamaha RX-V3800 Bedienungsanleitung Seite 131

HDMI
Error message
Device Over
The number of the connected HDMI
components is over the limit.
HDCP Error
HDCP authentication failed.
HDMI Message
Out of Resolution The connected monitor is not compatible
with the resolution of the input video
signal or input video signal is the analog
component video signal with 1080p of
resolution.
Network and USB
Problem
The PC server/MCX-2000/
Internet Radio does not
function properly.
The music in the PC
server cannot be played
back.
Windows Media Player 11
or Windows Media
Connect 2.0 cannot be
connected.
The MusicCAST server
cannot be connected.
"Disconnected" is
displayed even when a
USB device is present.
The Internet Radio cannot
be played.
Cause
Cause
Cause
The IP address is not set properly.
The network cable is not connected.
The PC does not have Windows Media
Player 11 or Windows Media Connect
2.0 installed in it.
The music is recorded in a format that
cannot be played on this unit. This unit
cannot play music formats other than
WMA, MP3 and WAV (PCM format).
Also note that it cannot play certain
music files even if these are recorded in
the WMA, MP3 or WAV format.
The music is copyright-protected.
The Windows XP PC is logging on to a
domain.
You are attempting to connect to
MCX-1000. The MusicCAST server that
can be connected by this unit is
MCX-2000.
Auto Configuration is not executed.
This unit recognized the USB device as
an illegal device.
The firewall of the network device is
activated. The Internet Radio can be
played only when it passes through the
port designated by each radio station.
The port number is variable depending
on radio station.
Connection to the Internet is
disconnected.
Remedy
Reduce the number of the connected HDMI
components.
Check that the connected HDMI components support
the HDCP copy protection standards.
Remedy
Set the resolution of the video output signal of the
input source component appropriately.
Remedy
Set the DHCP server function of the router to ON.
Alternately, perform manual configuration
according to the current operating environment.
Connect it properly.
Install Windows Media Player 11 or Windows
Media Connect 2.0 in the PC.
Play music recorded in a format that this unit is
compatible with.
This unit cannot play copyright-protected music.
Log on to the local machine instead of the
domain.
Use MCX-2000 or the PC server.
Execute "Auto Configure".
Turn this unit off then on again.
Check the firewall setting of the network device.
Check the configuration of the network device,
and then contact the network connection provider.
Troubleshooting
See
page
—
—
See
page
—
See
page
91
31
—
—
—
—
—
63
65
—
—
129
En