Installing Batteries In The Remote Control; Using The Remote Control - Yamaha RDX-E700 Bedienungsanleitung

INSTALLING BATTERIES IN THE REMOTE CONTROL

Press
■ To replace the batteries
Change all of the batteries if the operation range of the remote
controls decreases.
Notes
• Do not use an old battery together with new one.
• Do not use different types of batteries (for example, alkaline
and manganese) together. Each type of battery has its own
characteristics even if they are similar in shape.
• If the batteries run out, immediately remove them from the
remote control to prevent an explosion or acid leak.
• Dispose of the batteries according to the regional regulations.
• If a battery starts leaking, dispose of it immediately. Be careful
not to let leaking battery acid come into contact with your skin
or clothing. Before inserting new batteries, wipe the
compartment clean.
• Replace the batteries within two minutes to preserve the
memory in the remote control.
MULTI JOG
PUSH-ENTER
STANDBY/ON
PHONES TIMER DISPLAY SOUND MODE
VOLUME
30˚ 30˚

USING THE REMOTE CONTROL

INPUT
Within 6 m
(20 feet)
1
Press the mark on the battery cover and
open the cover.
2
Insert the two supplied batteries (AA, R06,
UM-3) into the battery compartment.
Make sure you insert the batteries according to the
polarity markings (+ and –).
3
Close the battery cover.
Use the remote control within 6 m (20 feet) of the DVD
receiver and point it toward the remote control sensor
(page 3).
Notes
• Be careful not to spill liquid on the remote control.
• Be careful not to drop the remote control.
• Do not leave the remote control in the following places:
– hot or humid places, such as near a heater or in a bathroom
– extremely cold places
– dusty places
13