Yamaha RX-V3800 Bedienungsanleitung Seite 85

Test Tone
Use this feature to select whether to turn on or off the
test tone output while you are adjusting the tonal
quality of each speaker.
Choice
On Outputs the test tone.
Off
Does not output the test tone.
2
Press 4 h to access the settings window.
Test Tone
Front L
Front R
Center
3
Press 4 k / n / l / h to select "PARAM" and
then press 4 ENTER to select a parameter
from "Band" (band), "Freq." (frequency) or
"Q" (Q factor).
y
You can adjust "Gain" (gain) with any parameter.
4
Press 4 n to select "EDIT" and press
4 ENTER to access the edit window.
For more information on the parametric equalizer and
each parameter, see page 139.
Test Tone
Front L
Front R
Center
The parameter selected in "PARAM" is highlighted.
• Press 4 l / h to adjust the parameter.
• Press 4 k / n to adjust the "Gain".
• Press 4 ENTER to exit the edit window.
y
• When you select "Band" in step 3, you can use this menu
as a graphic equalizer.
• The "Band #1" and "Band #2" can adjust the frequencies
below of 198.4 Hz.
• When you select "Subwoofer" in step 1 and "Band" in
step 3, you can adjust "Band #1" and "Band #2" only.
Functions
PARAM RESET
EDIT EXIT
Band / Gain
Band #1
Gain 0.0dB
Freq. 62.5Hz
Q 1.000
Graphical user interface (GUI) screen
5
Repeat steps 3 and 4 until you are satisfied
with the results.
y
If you want to reset all "Parametric EQ" parameter settings
for the selected speaker, select "RESET" and press
4 ENTER.
Select "EXIT" and press 4 ENTER to exit the
6
settings window.
Tone Control (Tone control)
Use this feature to adjust the balance of bass and treble
output to your speakers or headphones.
Note
Tone Control is not effective when:
– PURE DIRECT (see page 51) is selected.
– MULTI CH INPUT is selected as the input source.
Control (Tone control)
Choice
Speaker Adjust the bass/treble balance of your speakers.
Headphone Adjust the bass/treble balance of your
headphones.
y
"Speaker" and "Headphone" adjustments are stored
independently. The adjustments for "Speaker" affects the front
left/right, center, presence left/right speaker channels and
Subwoofer channel.
Bass (Bass control)
Use this feature to adjust low-frequencies output to your
speakers or headphones.
Choices: 125Hz, 350Hz, 500Hz
Control range: – 6.0 dB to +6.0 dB
Initial setting: 0.0 dB
Control
Bass
Treble
Auto Bypass
Functions
Speaker
Freq : 350Hz
Gain : 0.0dB
+6
0
-6
83
En