Yamaha DSP-A595 Bedienungsanleitung Seite 22

4
Set BASS, TREBLE and BALANCE to the "0" position.
Front panel
5
Press TEST (so that "TEST LEFT" appears on the
display).
Remote control
22
6
Turn up the volume.
You will hear a test tone (like pink noise) from the left main
speaker, then the center speaker, then the right main
speaker, then the right rear speaker, and then the left rear
speaker, for about two seconds each. The display changes
as shown below.
Appears.
* If the function "1. CNTR" in the SET MENU mode is set to
the NONE position, you will hear the center channel test
tone from the left and right main speakers.
7
Adjust BALANCE so that the sound output level of the
left main speaker and the right main speaker is the
same.
Remote control
Main (L)
Center
Main (R)
Rear (R)
Rear (L)
Front panel