Selecting The Speaker System - Yamaha DSP-A595 Bedienungsanleitung

4
For the DVD/LD or TV/DBS source, the current input
mode is also shown.
* To change the input mode for the DVD/LD or TV/DBS
source, press INPUT MODE (or the button that you
have pressed to select the input source in step 3 on
the remote control transmitter) once or more until the
desired input mode (AUTO or ANALOG) is shown on
the display. (See page 26 for details on switching the
input mode.)
Front panel
5
Select the main speakers to be used.
Front panel
* If you use two main speaker systems, press both A and B.
6
Play the source.
7
Adjust the volume to the desired output level.
Front panel
Remote control
or
Input mode
Remote control
or
8
If desired, adjust BASS, TREBLE, BALANCE, etc.
(see below) and use the digital sound field processor.
(see page 29.)

Selecting the SPEAKER system

Because one or two speaker systems (as main speakers) can
be connected to this unit, SPEAKERS allow you to select
speaker system A or B, or both at once.
Adjusting the BALANCE control
Adjust the balance of the output volume from the left and right
speakers to compensate for sound imbalances caused by
speaker location or listening room conditions.
Note
This control is effective only for the sound from the main
speakers.
Adjusting the BASS and TREBLE controls
BASS: Turn this clockwise to increase (or counter-clockwise
to decrease) the low frequency response.
TREBLE: Turn this clockwise to increase (or counter-clockwise
to decrease) the high frequency response.
Note
These controls are effective only for the sound from the main
speakers.
25