►
Fasten connecting piece with quick-release cou-
pling A on the frame, using fastening clamp G, and
install optics holder RT081R (see instructions for
use TA009907).
Uncoupling the radiolucent valve
Note
Radiolucent valve D can be uncoupled in two different
ways.
►
Grasp the coupling and press with the thumb on
pin 1 of valve D.
- or -
►
Push forceps K with the jaw side 2 under the cou-
pling and use the forceps bolt 3 to push them onto
the pins 1 of the valve D, see Fig. 5.
3
1
Fig. 5
K
2
Mounting the fastening clamp on the
frame
Loss of approach due to incor-
rect mounting and closing of
the fastening clamp!
WARNING
►
►
Loss of the fastening nut and
the upper clamping element
caused by complete removal of
CAUTION
the fastening nut!
►
►
Loosen fastening nut 1 by 2–3 counterclockwise
turns.
►
Click the fasting clip G into the desired position
onto the frame 4 (BV814R/BV815R), see Fig. 6.
Fastening clamp G is fixed on frame 4.
1
click
Fig. 6
Firmly tighten the fasten-
ing nut.
Always engage the cou-
pling bars and the frame
until they click.
Only loosen the fastening
nut by 2–3 turns.
2-3
G
4
7