Fault - Angelo Po 091FR7GD Bedien- Und Installationshandbuch

The appliance has been tested before being put
into service.
The information provided below is intended to as-
sist in the identification and correction of any anom-
alies and malfunctions which might occur during
use.

Fault

Smell of gas.
The flame is yellow.
The appliance does
not heat up.
The control panel does not
come on
IT IT
Alarm
GB
GB
E00
DE DE
FR
FR
ES
ES
E01
E.01
English
TROUBLESHOOTING
Occasional leak because flame
Burner dirty, heat exchange pipes
clogged, condensation drips.
Contactor not receiving power or
Electronic circuit board not
receiving electrical power.
TABLE OF ALARM INDICATIONS
Safety thermostat failure
Start the cooking well probe
Start the cooking well probe
FAULT
The user can solve some of these problems him-
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
out by qualified staff with recognised experience
acquired in the specific sector of operation.
Causes
has gone out.
faulty.
Cause
- 20 -
Remedies
Turn off the gas supply tap and
ventilate the room.
Information
Contact the after-sales
service..
Check the thermostat and activate
any start-up enabling device.
Check or replace the contactor
coil.
Check or swap the phase wire
connections.
Remedy
The appliance's functions are
disabled so no cooking cycles
can be carried out.
Reset the safety thermostat (see
page 16); if the problem persists,
call the after-sales service.
The appliance's functions are
disabled so no cooking cycles
can be carried out
Importante
Contact the after-sales
service
The appliance's functions are
disabled so no cooking cycles
can be carried out
Importante
Contact the after-sales
service
6