Reception Of The Machine; Unpacking - OEM START Gebrauchs- Und Instandhaltungshandbuch

2.3 - RECEPTION OF THE MACHINE

Upon reception of the machine make sure that the pack-
ing is complete and not damaged. Should the packing
be complete, remove it as specify at point 2.4 (aside
from different manufacturer's instructions).
Check if the instruction booklet is inside the packing
as well as the components specified in the transport
documentation.
In case any damage or defect is found:
a- Inform immediately the transport company and your
agent, both by phone and by registered letter with
return receipt;
b- Manufacturer shall also be informed.
IMPORTANT
The oven consists of three distinct parts:
support, oven, hood.
Eeach part is packed, separately; on instal-
lation, the components are assembled.
2.4 - UNPACKING (Fig. 3)
To remove the oven from its packing, proceed as follows:
• Cut the straps (1) that tie up the carton.
• Open the carton (2), by removing the metallic clips.
• Remove the cardboard packaging (2).
• Check if everything is complete.
• Open the oven door (3), remove the refractory mate-
rial fastening carton and the loose components, as
well.
• Check if the delivery is complying with the PACKING
LIST.
DANGER
The packing elements ( plastic bags, car-
ton, nails, etc...) shall be kept away from
the reach of the children, since they are
potential danger sources, so, they shall
be gathered and sent to special centres to
correctly be recycled.
IMPORTANT
A message concerning possible damages,
troubles or a non-compliance in comparison
with the description in our packing list shall
timely occur, anyway it shall latest occur
within 8 days from the receipt of the oven.
Otherwise, the goods will be considered as
accepted.
EN - 8
Technical data - Transport and unpacking
FIG. 3
START
3