Reference Normative; Description Of The Symbols - OEM START Gebrauchs- Und Instandhaltungshandbuch

- TAKE HIGHEST CARE TO THE WARNING
PLATES BEING ON THE OVEN, WHEN YOU
ARE GOING TO CARRY OUT OPERATIONS
ON OR NEAR IT.
- The user is obliged to keep all the warning
plates in legible conditions and, if required, to
change their position in order to make them
fully visible to the operator.
- Moreover the user is obliged to replace any
warning plate that, for any reason, has been
damaged or is not clearly legible. New warning
plates can be obtained through our Technical
Service Centre.
- It is strictly forbidden to carry out repairs
when the oven is functioning.
- In case of malfunctioning of the oven or dam-
aged oven components, please contact the
person in charge of maintenance, without
carrying out arbitrary repairs.
- It is strictly forbidden to make an improper
use of the oven.
The oven shall always be used as provided
for by good, scrupulous technique rules, ac-
cording to 89/392 EEC direction as well as
workers' health & safety standards as per
legislation being in force in the oven utiliza-
tion Countries or, in the event the latter do
not exist, according to 89/391 EEC direction.
- The manufacturer declines all responsibil-
ity for any injury or damage to persons or
things arising from inobservance of the
safety regulations and the instructions
contained in this manual.
- THESE SAFETY REGULATIONS INTE-
GRATE OR COMPLEMENT THE LOCAL
SAFETY REGULATIONS.
- NEVER carry out hasty or makeshift re-
pairs which could jeopardize the oven
functioning and user's safety, as well.
- IN CASE OF DOUBT ALWAYS ASK FOR
THE PRESENCE OF SKILLED PERSON-
NEL.
EN - 4
General specifications and warning
- MANUFACTURER DISCLAIMS ALL RE-
SPONSIBILITY IN CASE OF ELECTRIC,
ELECTRONIC, MECHANICAL TAMPERING
OF THE OVEN BY USER OR CARELESS-
NESS OF USER BY USING IT.

1.2 - REFERENCE NORMATIVE

- The oven and its safety devices have been built ac-
cording to the rules being indicated in the declaration
of conformity.

1.3 - DESCRIPTION OF THE SYMBOLS

Several accidents are due to an insufficient knowl-
edge and a lack of fulfilment of safety rules to be
considered during functioning and maintenance of
the oven.
To avoid accidents, all warning notes and instruc-
tions contained in this handbook as well as the ones
being reported on the oven plates, shall be read,
understood and observed.
To identify the safety messages included in this book-
let, following symbols have been used:
DANGER
This symbol is used in the safety messages
contained in the booklet in case of potential
danger situations or possibility to cause
serious injuries or dead.
ATTENTION
This symbol is used in the safety messages
of the booklet for any danger situation that,
if disregarded, may cause small or moder-
ate injuries or damages.
The message can also be used as to
dangers which can damage the oven.
START