Convotherm mini OES 6.06 Installationshandbuch Seite 23

2. Unit Connection
Positioning the unit
Unit dimensions:
Without
packaging
515 mm
Width
599 mm
Depth
Height 627 mm
Weight 45 kg
(99.2 lbs)
• Unit must be installed level
• Do not install the unit in the immediate
vicinity of a source of heat or steam or a
deep fat fryer, nor close to combustible
surfaces.
Safety distances
• left/right:
50 mm
• to the rear:
50 mm
• above:
500 mm (for ventilation)
Electrical connection (D)
Optionally 1/N/PE 230V 50/60Hz or
3/N/PE 400V 50/60Hz (modifiable on site)
Connected load [kW]
Rated current [A]
Connection cross-
section* [mm²]
* Recommended connection cross-section laid free
in air at max. 5 m length!
• Main switch (all-pole separator) is to
be installed by the customer in the
vicinity of the unit.
• Connection for potential equalisation
(E).
(cf. Chapter 2.1)
With
packaging
580 mm
730 mm
800 mm
57 kg
(125.7 lbs)
(cf. Chapter 2.2)
1/N/PE 3/N/PE
230V 400V
3,0 5,7
13,1 11,8
3 x 2.5 5 x 2.5
Water connection (A)
• Cold water ¾" 2 to 6 bar flow pressure
• Water tap and filter are to be installed by
the customer in the vicinity of the unit
• Water: Drinking water quality with
total hardness: 5-7°dH (soft water)
pH:
Conductivity:
-
Cl :
-
SO :
4
Fe:
Mn:
Cu:
max 0.1mg/l
If necessary install water treatment
(recommendation Brita)
• Total water consumption (guide value):
Drainage connection (C)
DN 40, recommended funnel siphon or
fixed connection
Ventilation
(cf. Chapter2.5)
3 NPE
Sensible heat output:
Latent heat output:
Other Data
Splash-water protection:
Test mark:
Noise emission:
Plug-in units 2/3 GN
(325x354mm):
Distance between units:
Accessory
Base frame:
Wall bracket:
Water drainage connection set: 3416709
Stacking kit:
23
EN
(cf. Chapter 2.3)
6.5 to 8.5
10-200µS/cm
max 0.1mg/l
max 0.1mg/l
max 0.1mg/l
max 0.05mg/l
max 0.05mg/l
15 - 20 l/h
Chapter2.4)
1100 kJ/h
1000 kJ/h
IPX4
CE
< 70 dBA
6
50 mm
article
number
3218570
3418571
3418572