Unox ChefTop Bedienungsanweisung Seite 6

ChefTop™ - BakerTop™
As soon as the set core temperature is reached, the
cooking step finishes and the following step (if selected) starts.
0°C
External core probe kit, XC240, is available to allow
you to connect a further small core probe, suitable
to vacuum cooking and small pieces of food.
Chamber temperature setting
The temperature inside the cooking chamber is
shown on the display panel 2 and is set with the but-
tons
0°C
Delta T setting
Delta T value is shown on the display panel 2 and is
set with the buttons
0°C
Climate setting
CLIMA LUX
The setting of the climate inside the cooking cham-
ber (STEAM.Maxi™ / DRY.Maxi™) is shown
by CLIMA LUX ellipse and is set with the buttons
.
ENGLISH
5
100°C
.
260°C
.
100°C
The 10 blue led's indicate the percentage of steam
inside the cooking chamber (STEAM.Maxi™); the
10 red led's indicate the percentage of dry air
(DRY.Maxi™).
DRY
Maxi
Cooking start / stop
To start a cooking cycle touch the
When the cooking starts, the led "START STOP"
turns on.
To stop the cooking cycle touch the button
When the cooking cycle has finished, both in ma-
nual and program mode, the oven makes an audible
alarm for 15 seconds and the display 1 flashes for 45
seconds. During this 45 seconds time the "START /
STOP" led remains on:
• if you touch the button
set cooking time. The oven automatically starts
again (with the last cooking cycle settings)
• if you touch the button
STOP" led turns off and all settings are reset.
• if none of the buttons are touched, after 45 sec-
onds have passed, "START / STOP" led turns off
and all settings are reset
Once the cooking cycle is finished, both in manual and pro-
grammed mode, if you push "P" button the 5 types display
will show "LASTP" message: by pushing "START / STOP"
button last cooking cycle that was used will start again.
3.6
Working with programs
The electronic control board allows the user to set,
and select, up to 70 cooking programs.
ENGLISH
STEAM
Maxi
button.
.
you increase the
the "START /