Time Setting - Unox ChefTop Bedienungsanweisung

ENGLISH
3.3 POWER UP / POWER DOWN
When the power to the oven is supplied, the control
board automatically turns on.
After 15 minutes if any button is not touched and there is
no appliance in use (ovens, blast chillers, holding cabinet)
the control board goes to stand by mode : only the led
"START / STOP" is on.
To return the electronic control to full power again, sim-
ply push the button.
To have the electronic control on stand by, keep the
button pushed for 6 seconds while the control is
on; to return it to full power push the
more.
3.4 COOKING CHAMBER LIGHT FUNCTIONING
The lights are normally turned off; every time you touch
one of the buttons they turn on for one minute then, after
one minute, they turn off. To turn them on again, push
any of the electronic control buttons.
3.5 MANUAL FUNCTIONING
Any cooking program may be composed of 4 steps.
To pass from one step to another touch the
the selected step is indicated by the illuminated led.
For each step the user can set the following settings:
• time or, as an alternative, core temperature
• chamber temperature or, as an alternative, Delta T
(available only if core temperature is set)
• climate inside the cooking chamber (STEAM.Maxi™
/ DRY.Maxi™).
To pass from one setting to another press the button
The selected setting is indicated by one of the illuminated
icons:
The settings "TIME" and "CORE TEMPERATURE" are
self cancelling: when selecting the "TIME", the "CORE
TEMPERATURE" setting will be inoperable; vice ver-
button once
sa, when selecting the "CORE TEMPERATURE" , the
"TIME" setting will be inoperable.
The "CHAMBER TEMPERATURE" and "Delta T" settin-
gs are also self cancelling: when selecting the "CHAMBER
TEMPERATURE", the "Delta T" setting will be inoperable
; vice versa, when selecting "Delta T", the "CHAMBER
TEMPERATURE" setting will be inoperable.
It is essential to select either the "TIME" or the "CORE
TEMPERATURE" setting: if none of these selections are
set, the control board does not allow the user to select
any of the following (cavity temperature, Delta T, Climate).
button:
.
UNO
Core Cavity
Time CORE CAVITY
TIME
Temperature Temperature
TEMPERATURE TEMPERATURE
SELECT
Time setting
The time is shown on the display panel1 and is set
with the buttons
When the display panel shows "inF", the oven will
work continuously until it is manually stopped by the
user. On cooking steps 2, 3 or 4, if the HOLD "HLD"
function is selected, the fans turns only when the
heating elements are on. Every time the fans start,
the direction of rotation reverses.
inF
0h 00'
Core temperature setting
The core temperature is shown on display panel 1
and is set with the buttons
R
Delta T CLIMA
DELTA T CLIMA LUX
LUX
T
CLIMA
LUX
.
9h 59'
STEP 1
.
ENGLISH
4