About System Reset Function; System Utility - Hitachi DV-P250E Bedienungsanleitung

About System Reset Function

The player can not work normaily with non-standard discs. If you encounter the abnormal status , please press
STOP button once to stop it. If it can't stop normaily, please press POWER/STANDBY button. If the status is
not changed in about 20 seconds after pressing POWER/STANDBY button then just press LAST button and
ENTER button concurrently on the front panel to reset the system. After reseting, the system will restart and
change into standby mode (The POWER/STANDBY indicator lights in red color ). Therefore, please press
POWER/STANDBY button again to start the system. (Pull out the power cord and plug it again, the restarted
system will also change into standby state.)

System Utility

How to upgrade the system utility
1. Power on the system and press the OPEN/CLOSE button to open the DVD-ROM tray.
2. Place the version-up CD-R disc into the DVD-ROM.
3. The DVD player will read the CD-R disc and upgrade the system utility version, after about 40 seconds,
the DVD-ROM tray will open automatically.
4. Take out the version-up CD-R disc.
5. Pull out the power cord then plug it again.
6. Press the POWER/STANDBY button to restart the system, while the DVD-ROM tray closed, the version
had been upgarded already.
NOTE: If the version of the system utility in the CD-R disk is older than original one, then the front display
window will shows 'No play'.
How to check the system utility version
1. At the power on state, press the POWER/STANDBY button and LAST button once in the same time and
then release the POWER/STANDBY button only and still press the LAST button continually for more than
5 seconds.
2. The front display window will appear the system utility version.
Chapter 1 25