Inhaltsverzeichnis
Werbung
Safety instructions
1
Safety instructions
Intended use
Force transducer in the KDB type series is designed solely for measuring static
and dynamic compressive forces within the load limits stated in the
specifications. Any other use is not the designated use.
To ensure safe operation, the regulations in the mounting and operating
instructions, together with the following safety rules and regulations, and the
data specified in the technical data sheets, must be complied with. It is also
essential to observe the applicable legal and safety regulations for the
application concerned.
The force transducers are not intended for use as safety components. Please
also refer to the "Additional safety precautions" section. Proper and safe
operation of force transducers requires proper transport, correct storage, setup
and mounting, and careful operation.
Load carrying capacities
The information in the technical data sheets must be complied with when using
force transducers. The respective specified maximum loads in particular must
never be exceeded. The following limits set out in the technical data sheets
must not be exceeded:
S Force limits
S Lateral limit forces
S Breaking forces
S Permissible dynamic loads
S Temperature limits
S Limits of electrical load-carrying capacity
Please note that when several force transducers are interconnected, the load/
force distribution is not always uniform, so an individual force transducer may
be overloaded even though the cumulative signal has yet to reach the sum of
the nominal (rated) forces of the sensors connected in parallel.
4
KDB
A04785_01_YCI_02 HBM: public
Werbung
Inhaltsverzeichnis
