Safety Instructions - HBM S2M Serie Montageanleitung

Safety instructions

1 Safety instructions
4
Designated use
The force transducers in the type series S2M are solely
designed for measuring static and dynamic tensile and/or
compressive forces within the load limits specified by the
technical data for the respective maximum capacities.
Any other use is not the designated use.
To ensure safe operation, the regulations in the mounting
and operating instructions, together with the following
safety rules and regulations, and the data specified in the
technical data sheets, must be complied with. It is also
essential to observe the applicable legal and safety regu­
lations for the application concerned.
The force transducers are not intended for use as safety
components. Please also refer to the section: "Additional
safety precautions". Proper and safe operation of force
transducers requires proper transportation, correct stor­
age, siting and mounting, and careful operation.
Loading capacity limits
The data in the technical data sheet must be complied
with when using the force transducer. In particular, the
respective maximum loads specified must never be
exceeded. The following limits set out in the technical
data sheets must not be exceeded
S Limit loads
S Lateral load limits
S Breaking loads
S Permissible dynamic loads
S Temperature limits
A3592-1.3 HBM: public
S2M