Siemens SINUMERIK 840DE sl Programmierhandbuch Seite 200

Fräszyklen
3.15 Taschenfräsen mit Inseln - CYCLE73, CYCLE74, CYCLE75
REPEAT TASCHE1_CONT ENDLABEL
CYCLE73(1015,"TASCHE1_DRILL","TASCHE1_MILL1","3",10,0,1,
-8,0,0,2,0,0,2000,400,0,0,0,1,4)
TASCHE1_BEAR_END:
REPEAT TASCHE1_CONT ENDLABEL
CYCLE73(1011,"TASCHE1_DRILL","TASCHE1_MILL1","3",10,0,1,
-8,0,0,2,0,0,2000,400,0,0,0,1,4)
;Ausraeumen der Tasche 2
G55
GOTOF BEISPIEL2_BEAR_END
BEISPIEL2_BEAR:
REPEAT BEISPIEL2_CONT ENDLABEL
CYCLE73(1015,"BEISPIEL2_DRILL","BEISPIEL2_MILL1","3",10,0,1,
-8,0,0,2,0,0,2000,400,0,0,0,1,4)
BEISPIEL2_BEAR_END:
REPEAT BEISPIEL2_CONT ENDLABEL
CYCLE73(1011,"BEISPIEL2_DRILL","BEISPIEL2_MILL1","3",10,0,1,
-8,0,0,2,0,0,2000,400,0,0,0,1,4)
;Ausraeumen Restmaterial Tasche1 und Tasche2
T6 M6
D1 G54 M3 S222
REPEAT TASCHE1_CONT ENDLABEL
CYCLE73(1012,"","TASCHE1_3_MILL2","3",10,0,1,-8,0,,2,,,2500,800,0,,,,)
G55
REPEAT BEISPIEL2_CONT ENDLABEL
CYCLE73(1012,"","BEISPIEL2_3_MILL2","3",10,0,1,-8,0,,2,,,2500,800,0,,,,)
G0 Z100
M30
;Rand- und Inselkonturen
;Tasche 2 entspricht dem Programmierbeispiel 2
Tasche 1:
%_N_Rand_MPF
;$PATH=/_N_WKS_DIR/_N_CC73BEI3_WPD
;29.03.99
N1 G0 X0 Y0 G90
N3 G1 X200 Y0
N5 X200 Y100
N10 X0 Y100
N20 X0 Y0
M30
200
Programmierhandbuch, 01/2008, 6FC5398-3BP20-1AA0
Zyklen