Selecting A Location; Fitting The Drive Elements - Truma Mover XT Gebrauchsanweisung, Einbauanweisung

Detailed installation instructions are included with each
mounting set.
The Mover® XT / XT2 must not be fitted to
caravans / trailers with other frames.
The vehicle frame must not be drilled (unless using the low
chassis kit* and the Eriba Touring mounting set) or welded.
Wheel suspension parts must not be removed under any
circumstances.
* In the case of the the AL-KO Vario III / AV chassis, the
vehicle frame must under no circumstances be drilled into
even if the low chassis kit is used.

Selecting a location

The Mover® XT / XT2 should preferably be mounted in front
of the axle, but in exceptional circumstances (e.g. lack of
space) it is also possible to mount it behind the axle. Only use
the bolts provided (or the mounting parts available as special
accessories) to attach the Mover® XT / XT2.

Fitting the drive elements

The frame of the vehicle must be free of rust, grease and
heavy soiling. There must be no damage in the area of the
wheel suspension.
The wheels and tyres fitted on the caravan must be of the
same size and type, and must be inflated in accordance with
manufacturer's instructions,
Remove all components from packing and place on the floor.
Fig. 16
In order to guarantee the validity of the general operat-
ing permit (ABE), the data plates (f) must be present on
the cross-strut on the right and left.
Fig. 17
Join the drive assemblies and the cross-strut together loosely.
Tighten the nuts (lock nuts), but no more than finger-tight.
Nut M8 (2 x)
Fig. 18
Place the drive assemblies with cross-strut and mounting kit (b)
on the vehicle frame and bolt them on with the two bolts (c) in
such a way that it is just possible to move them along the frame.
f
M8 x 30 (2 x)
The gripper (a) must rest completely on the chassis
frame.
Fig. 19
b
Fig. 20
If the frame is not high enough, Truma can provide 30 mm
and 60 mm spacer sets as accessories in order to compen-
sate for this.
30 mm spacer set, part no. 60030-95000
60 mm spacer set, part no. 60030-95100
Make sure that there is adequate ground clearance (at least
110 mm).
Driving direction
Fig. 21
Set the correct distance between tyres and rollers (28 mm)
with the spacer gauge provided by moving the drive assem-
blies (in the disengaged position) in the longitudinal direction.
The adjustable centre bar makes it possible to adjust to the
frame width.
Driving direction
Fig. 22
Move the drive assemblies in a transverse direction in such a
way that as much of the tread area of the tyre/drive roller as
possible is covered.
Mover
min. 110 mm
28 mm
min. 110 mm
23