Selecting A Location; Mud Guards; Fitting The Drive Elements - Truma Mover XT Gebrauchsanweisung

10. Short mounting system
Replacement for standard mounting system if this cannot be
used due to lack of space and to compensate for the height
(30 or 60 mm) of substructures such as tanks.
Part. no. 60031-20000
Figure 18
11. Mud guard set (no illustration)
Replacement for the standard mud guards, if these cannot be
adapted to the Mover®.
Part. no. 60031-08200
In some cases installation is not possible because of the
design of the sub-frame. Contact your dealer if necessary.
Detailed installation instructions are included with each
mounting set.
The vehicle frame must not be drilled (unless using the low
chassis kit* and the Eriba Touring mounting set) or welded.
Wheel suspension parts must not be removed under any
circumstances.
* In the case of the AL-KO Vario III / AV chassis, the vehicle
frame must under no circumstances be drilled into even if
the low chassis kit is used.

Selecting a location

The Mover® XT should preferably be mounted in front of the
axle, but in exceptional circumstances (e.g. lack of space) it
is also possible to mount it behind the axle. The Mover® XT2
should preferably be installed behind the axle Only use the
bolts provided (or the mounting parts available as special ac-
cessories) to attach the Mover® XT / XT2.

Mud guards

When a Mover® is fitted, the existing mud guards must be
moved / adapted if necessary (max. distance between tyre /
mud guard 300 mm).
If the original mud guards cannot be used, the Truma mud
guard set (part no. 60031-08200) must be used and adapted.
The mud guards are installed behind the axle. No mud
guards are required in front of the axle.
Mover® XT, XT2
Driving direction
Figure 19
24
Adapting the mud guards to the Mover®
1. Remove the mud guards.
2. Fit Mover® in accordance with the following installation
3. Determine dimensions a and b and transfer to mud guards.
Determining the cut-out sizes
Figure 20
Cut out the template on the last page of the installation in-
structions, place it onto the mud guard, transfer the contours
and cut out.
If necessary, make recesses in mud guard for apron contour
and attach mud guard to underside of caravan 300 mm from
tyre.

Fitting the drive elements

The frame of the vehicle must be free of rust, grease and
heavy soiling. There must be no damage in the area of the
wheel suspension.
The wheels and tyres fitted on the caravan must be of the
same size and type, and must be inflated in accordance with
manufacturer's instructions.
Remove all components from packing and place on the floor.
max.
Figure 21
300 mm
on the cross-strut on the right and left.
Mover
max. 200 mm
Figure 22
instructions.
The top leg of the fastening bracket must face towards the
rear of the caravan.
Mover® XT, XT2
a
b
Pay attention to left and right sides!
In order to guarantee the validity of the general oper-
ating permit (ABE), the type plates (f) must be present
a
Mover® Mover® XT / XT2 XT / X X XT2
b
f