Adjusting The Height Of The Cover To The Ground; Smart Control Box - SFA SANIFOS 110 Montageanleitung

In the case of an installation where there are water tables or impermeable or clayey surfaces, the bottom of the pit must be covered with a bed
of sand approximately 20 cm thick (mixture of sand and dry cement with a ratio of 200 kg of cement per 1 m
If there is an apparent groundwater table on the surface, replace the compacted sand with a cement-poor mixture (the space between the
tank and the pit must be at least 20 cm).
NOTE:
Ensure all pump preparation and piping connection work has been completed before burying the tank.

5.3 Adjusting the height of the cover to the ground

The non-slip cover is secured by screws on the SANIFOS
SFA can optionally provide a 300 mm extension for SANIFOS
It is forbidden to park or drive on the SANIFOS
pedestrians walk.
The maximum permissible weight, on an occasional basis, is 200 kg on the SANIFOS
It is strictly forbidden to walk on the SANIFOS
The power supply must be class 1.
The device must be connected to an earthed junction box. The power supply circuit must be protected by a 30 mA differential circuit-breaker
rated at 16 A for single-phase SANIFOS® 110, 250 and 500. For the SANIFOS® 500 Vortex three-phase version, the power supply circuit
must be protected by a 32A-rated 30mA tri-polar circuit breaker.
This connection must be used exclusively for the SANIFOS® power supply. If the cord of this device is damaged, it must be replaced by the
manufacturer or its after-sales service in order to avoid any danger to users.

6. SMART CONTROL BOX

Electrical connection work performed by an unqualified individual. Risk of death by electric shock!
➜ The electrical connection must be performed by a qualified and licensed electrician.
➜ The electrical installation must meet the current standards in the country.
Rating plate
250 and SANIFOS
®
250 and SANIFOS
®
110 pumping station.
®
4
1
2
500.
®
250 and SANIFOS 500 models.
® ®
500 pumping stations. They must not be installed where
®
1 Name of the pumping station
3
5
2 Name of the control box
3 Supply voltage
4 Power consumption of the engines
5 Frequency
6 Protection index
7 Date of production
7
6
sand)
3
250 and SANIFOS 500.
® ®
UK
129