Amann Girrbach ceramill motion 2 Betriebsanleitung Seite 83

▷ Using the spindle wrench, unscrew the collet out
of the spindle.
Fig. 31
▷ Clean the collet holder using the felt cone [3].
The collet holder must be free of shavings/chips
and debris.
Fig. 32
▷ Clean the inside of the collet with the fine collet
brush [2].
Fig. 33
▷ Apply a light coat of the collet grease ([1] in
Fig. 29 on page 82) from the service set to the
outer cone of the collet.
This improves the sliding properties and
increases the clamping force of the collet.
C L E A N I N G A N D M A I N T E N A N C E
3
2
NOTE:
Only use the provided collet grease for lubrica-
tion of the collet cone. Do not use other types of
grease.
▷ Screw the cleaned and lubricated collet in
reverse order to the stop back into the spindle.
CAUTION:
Danger of tool breakage!
▷ Make sure to remove the milling tool from the
collet chuck!
When the milling tool was from the Ceramill
Motion 2 tool holder:
▷ Place the tool properly positioned back into the
tool holder.
E N
83