Amann Girrbach ceramill motion 2 Betriebsanleitung Seite 64

I N S T A L L A T I O N
Connecting the interfaces
E N
Fig. 12 Interfaces on the rear side of the Ceramill
Motion 2
1 USB data port
2 Ethernet interface
3 Control interface for Ceramill Coolstream
4 Slot for SD memory card
5 Control interface for extraction
6 Main switch
7 Power supply connection
▷ Make sure that the main switch [6] of the
Ceramill Motion 2 is in the 0 position.
▷ Check if the SD memory card is properly seated
in the slot [4] on the rear side of the Ceramill
Motion 2.
▷ Connect the mains cable to the power supply
connection [7] of the Ceramill Motion 2 as well
as to a mains socket outlet.
For installation without Ceramill Coolstream:
▷ Connect the control cable to the control inter-
face for extraction [5] on the rear side of the
Ceramill Motion 2 and to the interface on the
rear side of the extraction system (e.g. to the
Ceramill Airstream).
64
2
1 3
4
6 7
For installation with Ceramill Coolstream:
5
Fig. 13 Interfaces on the rear side of the Ceramill
Coolstream
1 Power supply connection
2 C/L supply line connection
3 Control interface for Ceramill Coolstream
4 Control interface for extraction (i. e. for
Ceramill Airstream)
▷ Connect the control cable to the control inter-
face for the Ceramill Coolstream on the rear
side of the Ceramill Motion 2 ([3] in Fig. 12) and
to the rear side of the Ceramill Coolstream ([3]
in Fig. 13).
▷ Connect the control cable of the extraction sys-
tem to the control interface for extraction on
the rear side of the Ceramill Coolstream ([4] in
Fig. 13).
▷ Connect the mains cable to the power supply
connection ([1] in Fig. 13) of the Ceramill Cool-
stream as well as to a mains socket outlet.
1
3 4
2